Skip to content

Proudly American | Family owned

Same-day service available

(352) 675-6376 Book Online

Leaking chimney flashing repaired in Apopka

Your free flashing inspection in Apopka comes first, and anything you book within 72 hours after it is 10% off.

  • Licensed & insured
  • Locally run
  • Family owned and operated
  • Same-day service available
4.8 out of 5 from 736 reviews
  • Google
  • Yelp
  • Facebook

Inside your chimney flashing quote in Apopka

Checked and noted by our local family team in Apopka, then explained in plain language.

  1. Step flashing along both sides
  2. Counter flashing and the joints that hold it
  3. Exposed fasteners and old mounting holes
  4. Findings that need a separate decision

What goes into a flashing job in Apopka

Practical points from our chimney flashing crew in Apopka.

Solar panels close to the chimney

Solar arrays sometimes sit tight against a chimney, which can limit the room needed to lift roofing and set new flashing. Panels also change where water runs on the roof, especially where rails or conduit cross near the chimney.

We check the clearance around the chimney before quoting. If panels need to be moved or shielded during the flashing work, we tell you up front so the solar installer can be booked. The repair is then planned around that access rather than squeezed in.

A skylight close to the chimney

A skylight near the chimney has its own flashing, and the two can share a strip of roof. Water that gets past one can show up beside the other. Skylights also come with their maker's own flashing kits, which govern that side of the repair.

We check both when they sit close together and tell you which one is letting water in. If the skylight flashing needs work, we point you to the right trade or include it in writing when we agree to handle it.

Scheduling flashing work around the weather

Flashing work opens the roof around the chimney, so it is best done in a dry spell. Sealants and fresh mortar also need time to set before they face heavy rain.

We schedule around the forecast and protect the open area if rain arrives unexpectedly. Mortar packed around new counter flashing is kept out of direct downpours while it firms up. If your chimney is actively leaking, ask about temporary protection until the full repair can be done.

The written record you keep after the job

After the repair you receive a written summary of the work, including the faces flashed, the metal and the method used for the counter flashing. That record helps the next roofer, chimney crew or buyer understand what is on your roof.

It helps us too if you call again. We can see what was done and compare any new symptom with the original scope instead of starting from zero. The record lists the date of the work as well, which helps anyone judging later whether a new stain is part of the old story or something new.

What people in Apopka ask about chimney flashing

Short answers from our chimney team in Apopka. Call for anything not covered here.

Should the flashing be replaced when I get a new roof?

In most cases, yes. The roofing around the chimney is already coming off, and reusing worn flashing puts old metal at the weakest point of a new roof. We can coordinate the chimney side with your roofer.

Could our downspout be part of the problem?

It can. When an upper roof drains onto the roof beside the chimney, one flashing face takes the whole stream, and even good flashing can be overwhelmed. We check where upper downspouts empty. Moving or extending one is gutter work, which we point out and leave to you or your gutter contractor unless we agree otherwise.

Request your free estimate

Share the job details and arrange a free inspection with our local team.

  • Free inspection
  • No hidden fees
  • Family owned and operated

Need an answer now? Call (352) 675-6376

Tell us what needs attention. We will contact you to arrange your free inspection.

Call(352) 675-6376