Local fireplace installers for Bel Air, route checked first
From a blank wall to a working wood fire in Bel Air, planned around your room, your roof and your budget.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Before any fireplace is ordered for your Bel Air home
The room, the attic and the roof are measured in person in Bel Air, and each result lands on your estimate.
- Listed chimney sections, firestops and attic shield
- Outside air kit and inlet location
- Permit and inspection timing planned in
- Electrical work by an electrician, listed separately
A fireplace installation in Bel Air, start to finish
Each point below turns into a line on your written estimate in Bel Air.
Air space around every chimney section
Chimney sections need their own clearance to framing. In one maker's instructions, a minimum air space of two inches is kept between the framing and the chimney section at any level, from the top of the fireplace to the roof.
That clearance governs how chases, closets and attics are framed around the pipe. We lay out the chimney route before framing begins, so the openings in each floor and ceiling are cut to leave the required space on every side, with nothing stuffed into the gap later.
Mantels and trim on a masonry fireplace
An exception in section R1001.11 lets exposed combustible mantels or trim sit directly on the masonry fireplace front around the opening, provided the combustible material is not placed within 6 inches of the fireplace opening.
Mantel choice and position therefore belong in the design stage, long before the finishing week. We mark the 6 inch line on the drawings and on the masonry itself, so the mantel and any wood trim are sized to it, and we tell the finish carpenter before the first piece is cut.
Carbon monoxide alarm rules for new fireplaces
Florida Statutes section 553.885 requires new buildings and additions that have a fossil-fuel-burning heater or appliance, a fireplace or an attached garage to have an approved operational carbon monoxide alarm installed within 10 feet of each room used for sleeping, or at other locations the Florida Building Code requires.
Where a new fireplace is part of an addition, that alarm requirement is part of the project. We point it out at the planning stage and list the alarm work separately.
Manufacturer warranty and our workmanship warranty
Fireplace makers tie their warranties to installation according to the manual, and the E-series manual notes that accessories not tested with the unit could void it. The product warranty and the installation are separate questions, and both matter to you.
Our workmanship warranty covers the work we perform, and installing to the manual protects the maker's warranty on the fireplace itself. At handover we explain which conditions apply to each, so nothing you do later cancels either one by accident.
Other work in Bel Air
-
-
-
-
-
-
Fireplace installation questions we answer in Bel Air
Undecided? These help, and the fireplace visit in Bel Air costs nothing.
What happens where the chimney passes through attic insulation?
Section R1005.8 calls for a steel insulation shield at least 0.0187 inch thick wherever a factory-built chimney crosses insulated space, so the insulation stays off the pipe. We fit the shield listed for your chimney system and check the insulation around it before we leave the attic.
Is a smell during the first few fires normal?
For a short while, yes. The early fires cure the paint and the materials inside the firebox, and most manuals ask for a run of smaller fires first. We light the first one with you, watch the draft with the doors open and shut, and suggest a window open while the curing finishes.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.