Your fireplace hearth, repaired and measured in Bel Air

Trim and mantels close to the opening

Hearth work often brings the surround into view. Another exception in section R1001.11 lets combustible mantels or trim sit on a masonry fireplace front only 6 inches or more from the opening, and inside the first 12 inches each inch of distance allows just 1/8 inch of projection.

Mantel rebuilding sits outside a hearth repair, yet we point out trim that sits closer than those numbers so you can decide how to handle it while the room is already under work.

Hearths in front of corner fireplaces

A corner fireplace throws its heat and sparks at an angle, and its hearth is often cut at angles to match. Those angles make it easy for one side of the extension to stop short of the distance past the opening that the code asks for.

We measure along each side of the opening as well as straight out from the center. Where one side falls short, we show how the extension can be reshaped so both sides meet the rule and the hearth still sits comfortably in the corner.

Condominium and association hearths

In a condominium or a community with an association, the hearth may belong to a unit that shares walls, chimneys or rules about visible changes.

We suggest checking with the association before choosing a new finish. The repair itself follows the fireplace and the code, and our written scope gives the association a clear description of what will change and what will stay.

• Association rules checked first
• A written scope for approval
• The repair itself follows the fireplace and the code

The front edge of a raised hearth top

The front edge of a raised hearth top, often a bullnose or a separate edge piece, carries weight when people sit and takes kicks from shoes. Its bond tends to break before the rest of the top.

A loose edge piece is removed, cleaned and reset on a fresh bed. If it keeps coming loose, we check the support under the overhang, since an edge that hangs past its base has little to hold it.