Family-owned chimney flashing repair in Belmere
Same-day service available in Belmere. We trace the leak to its face, repair the flashing and leave the roof tidy.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Inside your chimney flashing quote in Belmere
Our crew in Belmere inspects these points at the roofline, then writes them into your proposal.
- Each chimney face where it meets the roof
- Old tar, caulk and patch metal to remove
- Cleanup and haul-away of old metal
- Findings that need a separate decision
How we handle chimney flashing repair in Belmere
The details below shape the repair we recommend in Belmere, and each one shows up in your written estimate.
Fastening step flashing to the roof, not the chimney
The roof and the chimney move independently. The chimney stands on its own foundation, while the roof framing shifts with heat and moisture. Flashing that is nailed to both can tear as they move.
That is why step and base pieces are fastened to the roof deck and covered by counter flashing that is fixed to the chimney. The two layers overlap without being tied together. We check how the existing pieces were fastened and correct any that pin the roof and chimney to each other.
Flashing bent to fit your chimney
Chimney flashing is usually formed from flat sheet on a brake, bent to the angles and widths each face needs. Stock pieces can work on the sides, but aprons, corners and back pans often have to be shaped to the chimney in front of us.
We measure each face and form the pieces to fit instead of forcing stock parts into place. A close fit at the corners and bends means less reliance on sealant to close gaps, and a cleaner look from the ground.
Stepped counter flashing along a sloping side
Mortar joints run level, but the roof beside the chimney slopes. Counter flashing on the sides is therefore cut in steps, each piece set into a different joint and trimmed at an angle to follow the roof line.
Each step must overlap the next one and cover the step flashing below it. Gaps between steps are a frequent source of leaks on older chimneys. We cut and fit every step to its joint and check the overlaps from top to bottom.
Flashing against a stone chimney
Natural and cultured stone have uneven faces and irregular joints, which makes setting counter flashing harder than on brick. Water can also run behind stone along joints that are not level.
We look for a joint or a line where counter flashing can be anchored and sealed properly. Sometimes a groove is cut to create a clean line across the stone. We explain the approach for your chimney before any cutting. Mortar joints between stones can also let water in above the flashing, so we look at the stonework just above the roofline before blaming the metal below it.
Other work in Belmere
-
-
-
-
What people in Belmere ask about chimney flashing
Answers from our specialists in Belmere, with no sales pressure.
Should the flashing be replaced when I get a new roof?
In most cases, yes. The roofing around the chimney is already coming off, and reusing worn flashing puts old metal at the weakest point of a new roof. We can coordinate the chimney side with your roofer.
Why is chimney flashing made in two parts?
Base flashing is fastened to the roof and counter flashing to the chimney, and the lap between them lets each move a little without tearing a seam. BIA Technical Note 19B treats them as separate pieces for that reason. One-piece metal run from the roof into a mortar joint cannot flex, so we replace it with a two-part detail.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.