Fireplace installation that starts at the roof line in Bithlo
From a blank wall to a working wood fire in Bithlo, planned around your room, your roof and your budget.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Before any fireplace is ordered for your Bithlo home
The room, the attic and the roof are measured in person in Bithlo, and each result lands on your estimate.
- Chimney route checked for offsets and elbows
- Listed termination cap and roof parts
- Glass doors and screen from the approved list
- Your 10% off for booking within 72 hours, written on the estimate
A fireplace installation in Bithlo, start to finish
Each point below turns into a line on your written estimate in Bithlo.
The insulation shield in the attic
Florida Residential Code section R1005.8 says that where factory-built chimneys pass through insulated assemblies, an insulation shield of steel at least 0.0187 inch thick, No. 26 gage, shall provide clearance between the chimney and the insulation.
In an attic with blown or batt insulation, that shield is what keeps insulation off the pipe. The E-series manual pairs it with a firestop spacer that supports it. We install the shield listed for your chimney system and check the insulation around it before we climb down.
Leveling the fireplace and squaring the opening
The E-series manual asks for the fireplace to be leveled side to side and front to back, shimmed with noncombustible material such as sheet metal, and secured to the framing with its nailing flanges. To make sure glass doors fit, it asks for the diagonals of the opening to be measured and made equal.
A fireplace set slightly out of square looks fine until the doors are hung. We level and check the diagonals before the unit is fastened, so the doors, the face finish and the hearth all line up later.
What zero clearance really means
Zero clearance is a common name for factory-built fireplaces that may be framed close to combustible materials at particular points. It describes where the standoffs let lumber touch the unit, and nothing more. It does not mean the fireplace can be wrapped in wood or packed with insulation anywhere.
The manual for a zero clearance fireplace still sets air spaces, face materials, mantel heights and chimney clearances. Our installers treat those numbers as the real specification and the name as a shopping category, which is why the framing plan comes from the manual table.
Checking the draft on the first fire
The first fire in a new fireplace is also the first test of the whole system. With the damper open, smoke should rise cleanly into the top of the firebox, and the house should not pull it back into the room when a door opens or the air conditioning starts.
We watch that first fire with you, check the draft with the doors open and closed and look at the chimney top once the fire is going. If anything needs adjusting, we say so on the spot rather than after we have packed up.
Other work in Bithlo
-
-
-
-
-
-
Answers on adding a fireplace for Bithlo households
Honest answers from our Bithlo fireplace specialists, no pressure attached.
How large must the hearth in front of a factory-built fireplace be?
Section R1004.2 hands that decision to the fireplace listing, so the manual sets the size and the material. Embers land there when a log rolls, which is why we build it to the manual, face it in the noncombustible finish you choose and point out its edges before the rugs go back.
Will our roof be left open overnight?
No. The chimney goes through a framed opening between rafters or trusses and is closed with the listed roof parts and a storm collar. Any open roof is covered at the end of each working day, and the estimate says how we reach the roof and protect it while we work.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.