Electric fireplace installation planned around your Carver Shores room
We check the model, the wall and the circuit in Carver Shores before install day. 100% satisfaction guaranteed on the work we do.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
What we measure in Carver Shores rooms before install day
These are the details that decide how the unit goes in. You see each one in writing before our Carver Shores team starts.
- Framed opening size and sill depth for a recessed unit
- Finish materials around the unit and where they stop
- Trim kit, surround or mantel work included
- Controls, remote and wall switch setup
What goes into an electric fireplace install in Carver Shores
Practical points from our electric fireplace installers in Carver Shores.
No extension cords or power strips
Plug-in electric fireplaces draw real current when the heater runs. Makers are direct about it. Dimplex's XHD firebox manual says to always plug the fireplace directly into a wall outlet and never use it with an extension cord or a relocatable power tap.
If the nearest outlet is too far away, the answer is a properly placed outlet, not a longer cord. We plan the fireplace position around existing outlets where possible and list a new outlet as electrical work where it is not. It keeps the setup safe and tidy.
Why shared circuits cause trouble
The National Electrical Code, NFPA 70, limits how much of a shared branch circuit's rating one plug-in appliance may use, in section 210.23. It sets a tighter limit for equipment fastened in place when the circuit also feeds lights or plug-in loads.
An electric fireplace heater running alongside a vacuum, a space heater or a game console can push a shared circuit past what it was sized for. We look at what else is on the circuit during the inspection. If the numbers do not work, the fix is a different circuit, not a hope that everything will not run at once.
Running the flame without the heat
On most electric fireplaces the flame picture can run on its own, heater switched off. That means the fireplace can be enjoyed on warm evenings for its look alone, with very little heat added to the room.
At the walkthrough, we show you how to switch between flame only and flame with heat on your model. We also point out brightness and color settings where your model has them, so you get the look you want without reading the whole manual.
Registering the model and serial
Makers ask owners to record the model and serial number and register the product. Dimplex points to a model and serial label on the unit and an online registration page.
We note both numbers for you, leave the manual with your records and show you where the label is. If the unit ever needs a part, that information makes the call to the maker quick. It also helps us if we are asked to service the fireplace later.
Other work in Carver Shores
-
-
-
-
-
Learn more about electric fireplace installationCarver Shores services
Asked in Carver Shores about installing an electric fireplace
Short answers from our fireplace team in Carver Shores. Call for anything not covered here.
Will you install a fireplace I bought online?
Yes. Send us the model number when you book so we can read its manual before the visit. If the model does not suit your wall, we tell you before anything is cut.
What happens to my old fireplace doors and grate?
We remove them and take them away as part of the job, and the removal is listed on your estimate. If you want to keep any of it, tell us and we will set it aside.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.