Your local chimney repair team in Corner Lake

Spot repair or rebuilding a section

The size of a repair follows the condition of the masonry around the damage, not only the damage itself. A few spalled bricks or eroded joints in a wall that is otherwise tight and plumb can be repaired in place, brick by brick and joint by joint.

It changes when masonry has shifted or sits out of line, or when cracks run through several units. BIA maintenance guidance treats that kind of movement as structural, so the cause is found first. Setting new brick into masonry that is still moving only buys time, and the sound approach is then to take the chimney down to a solid course and rebuild from there, anchored and supported the way the Florida Building Code requires.

Before choosing, our technicians check the masonry around every damaged area. Your Corner Lake estimate shows which approach we recommend, how far down a rebuild would go if one is needed and why a smaller repair would not hold.

A damper that will not open or close fully

A masonry fireplace is supposed to have a damper. Under the Florida Building Code it is a ferrous metal damper, installed in the fireplace or in the chimney that vents it, and operable from the room. A typical one is a metal plate in a frame just above the firebox, moved by a handle or a rod.

Rust sets in on the plate and frame, and then the damper sticks halfway, the handle turns without moving it or it closes with a gap. EPA wood-burning guidance lists a damper that is not open wide enough among the conditions under which creosote tends to build up. One that will not close leaves the flue open to the house.

Rust on a damper is also a clue that water is getting in from above, so the top gets a look too. Our chimney damper repair service decides between freeing the old damper and replacing it, and your Corner Lake estimate lists the damper and any repair at the top as separate items.

The cleanout door at the base of a flue

A small metal door at the bottom of a chimney, outside or in a utility space, is usually a cleanout. The Florida Building Code requires a cleanout opening close to the base of each masonry chimney flue, with a noncombustible cover, so ash and debris can be taken out. Fireplace flues that can be cleaned through the fireplace opening are the exception.

Cleanout doors rust, warp and lose their latches. One that is missing or hangs open gives animals and water an easy way in, and one rusted shut leaves debris sitting at the base out of sight.

Replacing the door is a small job, but the frame has to sit tight in the masonry so the new cover closes properly. The base of the flue is cleared first, then a noncombustible door and frame are fitted. Any of these signs puts the door on the estimate.

• A door that will not latch or close flush
• Rust holes or a warped frame
• Loose mortar around the frame
• Ash or debris spilling from the opening

Workmanship warranty and 100% satisfaction

Approved repairs are backed by our workmanship warranty, and every job carries our 100% satisfaction guarantee. Those promises mean the most when the work itself is clear, so they sit on top of a written estimate that names each repair.

A clear scope protects both sides. If the estimate says the crown is replaced, the counterflashing is reset into the mortar joints and two courses of brick are rebuilt, you know exactly which work is ours and what was done to your chimney.

Some limits are honest to state up front. A repair to one part of a chimney does not make the rest of it new, and parts left in place are listed as left in place. Homeowners in Corner Lake can ask about the warranty when they review the estimate, and ask again about anything that is not clear.