Your fireplace repair team in Countryside
Smoke, smells or a fire that will not draw? We trace the cause at the fireplace and fix what we find.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Parts and finishes on your Countryside fireplace estimate
- Listed parts for factory-built units
- Outside air control and duct where fitted
- Room protection and cleanup
- Care notes for the first fire after repair
Our approach to fireplace repair in Countryside
Gaps opening up between the firebricks
The joints between firebricks are meant to be thin. The Florida Building Code limits them to no more than a quarter inch. When joints wear back, crack or fall out, the lining loses the tight surface the code describes and loose bricks can start to shift in the wall.
We probe the joints to find the soft ones, rake them out and refill them with medium-duty refractory mortar. Where bricks have loosened, they are taken out, cleaned and reset. Joints on the room side of the fireplace, outside the firebox, are a separate job and may call for a different mortar.
The estimate shows how much of the firebox needs new joints, so you can see whether the job is a spot repair or new joints across the whole lining. Any bricks that need resetting are listed on their own line.
Mesh curtains and screens that sag or tear
NFPA advises a sturdy fireplace screen to stop sparks flying into the room. Many fireplaces have mesh curtains that hang from a rod and slide open, and those curtains can tear, sag, wear through at the bottom or come off their rings.
A gap at the side, a hole low in the mesh or a curtain that will not close fully lets sparks and rolling embers reach the hearth and beyond. A freestanding screen that does not fit the opening does the same thing.
Torn mesh is replaced, rods and rings are renewed and curtains are adjusted so they meet in the middle. On factory-built units, screens come from the maker's parts list. For masonry fireplaces, we measure the opening and fit a screen that covers it. Screen parts are listed with their sizes, which makes a future replacement simple.
Ash dump doors that stick or stay open
Some masonry fireplaces have an ash dump, a small metal door in the firebox floor that drops ash into a chamber below. The chamber is emptied through a separate cleanout door, and where that door sits depends on how the fireplace was built.
The dump door can rust, warp or jam with ash. One stuck open can let air into the fireplace from below. The cleanout door can rust shut or go missing, and the chamber itself can fill to the top without anyone noticing.
Our crew frees or replaces the dump door and its frame, replaces a missing cleanout door and empties the chamber if it is full. Each door is priced on its own line for Countryside homeowners, and any ash we remove goes out in a covered metal container, as EPA wood-burning guidance advises.
The written estimate lists parts, finishes and exclusions
A fireplace repair estimate should leave nothing to guess. Ours names the fireplace type and model, the part or area being repaired, the materials and parts we plan to use and any finish work, such as resetting tile or matching grout. Where a factory-built part is involved, the maker and model number are on the page too.
It also lists exclusions. Work above the damper, leaks from above, gas or electric appliance faults and anything we could not reach are written as separate items or clearly left out. Pricing is upfront, there are no hidden fees and nothing starts until you approve it.
For homes in Countryside, the estimate is free and follows the inspection, never a phone guess. If something changes once work starts, such as damage hidden behind a face, we stop and show you before going any further.
Other work in Countryside
-
-
-
-
- Fireplace InstallationPlan the fireplace before opening the wall.
- Fireplace RestorationBring an unused fireplace back with a coordinated plan.
Learn more about fireplace repair and serviceCountryside services
Related fireplace repair work
-
-
-
-
Your fireplace repair questions, answered
Can glass doors be added to my factory-built fireplace?
Only doors the fireplace's manual and listing allow, and a gasketed door only where the fireplace system has been tested, listed and labeled for it, as the Florida Building Code requires. We check the manual before recommending any doors.
Is the repair covered after you leave?
Yes. Our workmanship warranty applies to each fireplace repair, alongside our 100% satisfaction guarantee. If something we fixed does not hold up as it should, we come back and put it right.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.