Honest chimney chase repair for Dover Shores West homes
Leaking chase? We cover it, trace the water and give you a free written estimate before any permanent work.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Your chase repair scope, layer by layer
- Tap test for hollow or loose stucco
- Step or L flashing where the chase meets shingles
- Cricket behind a wide chase where needed
- Wiring or insulation moved out of the clearance
Chimney chase repair, explained for Dover Shores West homeowners
Rotted roof deck around the chase base
Water that rots the bottom of a roof chase often reaches the roof deck under it. The plywood around the chase opening goes soft, the shingles above it sag, and the rafters or blocking under the chase may be wet too.
The chase sits on that roof framing, so a soft deck is a structural question as well as a roofing one. It also affects how the new chase framing is fastened down, since the base plate needs firm wood under it. Replacing chase siding over a rotted deck leaves both the leak and the weak base in place.
Once the base of a chase in Dover Shores West is open, the deck and blocking are checked by hand, and new framing never goes down on soft deck. Deck repair is listed separately, and if your roofer is handling the shingles, we agree on who replaces which pieces before work starts.
Firestops where the pipe passes a floor or ceiling
Where a factory-built chimney passes through a floor or ceiling, the chimney maker calls for a firestop, a metal plate that closes the framed opening while keeping the air space around the pipe. DuraVent's DuraChimney II instructions, for example, call for a firestop at every floor and ceiling level, including where the chimney enters the attic, but not at the roof.
The Florida Building Code, in R302.11, also calls for fireblocking in concealed spaces of wood-framed walls at ceiling and floor levels. Each plate is fastened to the framing as the maker shows, with the air space around the pipe left open.
Each firestop gets checked for position, fastening and damage whenever a chase is opened. Missing or damaged firestops are replaced with the chimney maker's listed part, and any that were missing are pointed out to you before the chase on your Dover Shores West home is closed.
Reading the chimney label before repairs start
Factory-built fireplaces and chimneys are listed and labeled, and the label names the maker, model and listing. Under R1004.1, factory-built fireplaces are tested to UL 127 and installed per their listing. R1005.3 ties factory-built chimneys for solid-fuel appliances to UL 103, and R1005.4 has chimneys for factory-built fireplaces meet UL 127.
The instructions that go with those labels decide the clearances, shields and supports inside your chase. The fireplace label is often inside the firebox opening or behind a panel, and original paperwork helps if you still have it. The chimney pipe itself may also carry a label on a section near the top of the chase.
Our technicians record the maker and model at the first visit, so the chase work follows the right instructions. If a label is missing or unreadable, we tell you how that limits the repair plan. This step comes before any framing is cut on a chase in Dover Shores West.
Save 10% on chase repair booked within 72 hours
Any service booked within 72 hours after the free inspection is 10% off, and chimney chase repair counts. A few boards at the base or a full chimney chase rebuild, the offer is the same.
The offer does not change how we scope the job. Hidden damage found once the chase is open is still written up and approved before it is done. You still get the free inspection, a line-by-line estimate and the same materials and methods. Siding, sheathing, framing, barrier and flashing are each priced on their own lines, with disposal, access and cleanup listed too, so you can see what the total is made of before you approve anything.
Book within 72 hours after the inspection, mention the offer, and our family-owned team will apply it to your chase repair in Dover Shores West. It pairs with our workmanship warranty and 100% satisfaction guarantee on the finished work.
Other work in Dover Shores West
-
-
-
-
-
-
Learn more about chimney chase repairDover Shores West services
Before you book chase repair in Dover Shores West
Can you repair only the rotted part of my chase?
Often, yes. When rot is limited to the base, a corner or the top, our crew removes siding in that area, replaces the damaged wood and laps new barrier and flashing into the old. If probing shows rot running through most of the framing, we price a rebuild alongside the repair so you can compare.
Can a chase be changed from siding to stucco?
Yes, as long as the framing is sound and flat. Stucco over wood needs a two-layer barrier, corrosion-resistant lath and three coats, so we price it as its own option next to a like-for-like siding repair.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.