Chase cover replacement by local pros in Dr. Phillips
One family-owned team measures and installs your Dr. Phillips chase cover, with the price written down before any metal is cut.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
What your Dr. Phillips chase cover estimate covers
- Chase measured over the finished siding on all four sides
- Cross-breaks or a pitched top that drains to the edges
- Hemmed drip edge on every side
- Written record of the installed cover
Getting the chase top right in Dr. Phillips
Chase cover or flue cap, which part failed
Two metal parts sit at the top of a framed chimney. The chase cover is the broad sheet that closes the top of the wooden enclosure. The termination cap is the smaller hooded piece fitted to the chimney pipe that rises through it. Rust can show on either one, and replacing the wrong part leaves the leak in place. Our first step on your Dr. Phillips roof is to name the failing component, then price only that component, with anything else on its own line.
Why a flat chase top holds rain
A chase cover cut as a flat sheet looks tidy on installation day. Once it flexes, the middle sinks a little and rain collects there instead of running off. Metal that stays wet under a puddle corrodes sooner than metal that dries between storms, and the pinholes tend to open right where the water sat. A replacement top needs shape, creased or pitched, so water leaves every edge and nothing lingers around the pipe collar. On your Dr. Phillips roof, a flat top also collects leaves and grit in that same low spot, which keeps the metal damp even longer.
Checking the termination height after roof work
Manufacturer instructions set how far the termination must extend above the roof. The rule in one manual we use calls for three feet above the roof penetration and two feet above any roof surface within ten feet. A thicker new roof or an added layer can change those measurements. We note the height as we work on your Dr. Phillips chase. If the chimney looks short for its surroundings, that becomes a separate conversation and a separate item on the estimate.
Coordinating with a roofer
The chase cover and the roof meet only at the base of the chase, where flashing ties the enclosure into the roof. During a reroof, that base flashing is usually redone by the roofer, while the cover at the top is a separate component. Scheduling the cover just before or right after the roof work avoids extra foot traffic on new shingles. We coordinate timing with your roofer and keep each contractor's scope in writing. If the roofer is already scheduled, tell us the dates so the cover can be measured before the old roof comes off.
Other work in Dr. Phillips
-
-
-
-
-
-
Learn more about chimney chase cover replacementDr. Phillips services
Related chase cover work
Your Dr. Phillips chase cover questions, answered
How long does chase cover replacement take?
It usually takes two visits. We measure at the free inspection, the cover is fabricated to those measurements, and installation follows once it is ready. You get a timeline when you approve the work.
Do I need to be home for the work in Dr. Phillips?
For the inspection, someone should let us look at the fireplace inside. Installation happens on the roof, so it can often be done while you are out, as long as access is arranged.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.