Fireplace repair and maintenance in Edgewood
Local, family-owned fireplace repair in Edgewood, with a free inspection and our 100% satisfaction guarantee on the finished work.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Your fireplace repair scope, line by line
- Damper handle, rod, chain or linkage
- Ash dump door and cleanout door
- Old patches removed and redone in refractory mortar
- Room protection and cleanup
The work behind a fireplace you can use again
A repair record that stays with the house
Houses change hands. Whoever buys your home, or the technician who comes next, will want to know what was repaired, with what and when. Without a record, a sound repair can look like an unknown patch and get torn out for no reason.
After each fireplace repair in Edgewood, we leave a written record of the work. It names the fireplace type, the model where there is one, the parts fitted and the materials used, such as refractory mortar in a firebox or a listed replacement panel in a factory-built unit. Items we found but did not repair are listed as well, with the reason.
Keep it with the owner manual. It helps at a home sale, on a future service call and whenever a question about the fireplace comes up years from now.
Rust holes or burn-through in a metal firebox
A factory-built fireplace is a metal box surrounded by air spaces and framing. When its floor or walls rust through or show a hole, heat can reach places the unit was never tested for. That is a reason to stop using the fireplace until it has been looked at, even if it still seems to burn normally.
Rust needs moisture, so our technicians look for where the water came from before anything else. Water getting in higher up the chimney is one source, and damp ash left sitting for months is another. A new part that goes into the same wet conditions will rust the same way.
Whether a damaged metal part can be replaced in your home is set by the maker's service instructions. Our crew explains which case applies to your model and puts it in writing before you decide, including the point at which replacing the whole unit becomes the sensible option.
Parts from another maker stay out
It is tempting to fix a factory-built fireplace with whatever fits. A universal grate, a panel from a similar model, doors sold to fit many openings or chimney pipe from another brand can look close enough. They are still not the parts the fireplace was tested with.
At least one chimney maker states the rule plainly. DuraVent's DuraChimney II installation instructions, as one example, say to use only that maker's listed parts and not to mix parts from other systems or improvise. The same thinking applies to the fireplace below, which is tested with its own components.
Every replacement is matched to the label and the manual. When a part is sold only by the maker, it is ordered through the maker's parts channel. If a proposed substitute has no listing behind it, we tell you and leave it out of the job, even when it would be quicker.
Gas fireplace faults get their own repair service
Gas fireplaces, gas inserts and vented gas log sets have their own parts, controls and venting rules. A pilot that will not stay lit, a burner that will not light, a remote that stopped working or glass that has clouded over are gas appliance faults, and our gas fireplace repair service handles them.
If you smell gas, do not light the fireplace or switch anything on. Leave the home and call the gas company or 911 from outside, as NFPA heating safety tips advise.
On a fireplace service call, our technicians still look at the masonry, hearth, surround and mantel around a gas unit, because those are fireplace repairs whatever the fuel. Estimates in Edgewood split the two kinds of work so each goes to the right technician, and both can be handled on one visit when the schedule allows.
Other work in Edgewood
-
-
-
-
-
Learn more about fireplace repair and serviceEdgewood services
Related fireplace repair work
-
-
-
-
Quick answers on fireplace service in Edgewood
Do you work on gas or electric fireplaces?
Those units go to our gas fireplace repair and electric fireplace repair services, which work from the makers' instructions. This repair service still handles the hearth, facing, mantel and masonry around them, and one estimate can cover both.
Should I light a fire to show you the problem?
No. Leave the fireplace cold and describe what you saw, when it happened and what the fire was like. Our technician checks it cold, which is safer, and your description fills in how the fire behaved.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.