
Leaking chimney flashing repaired in Fairvilla
Stop water where the chimney meets the roof. Local pros in Fairvilla repair the flashing itself, and work booked within 72 hours is 10% off.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
The written flashing scope for your Fairvilla home
These are the details that decide how the flashing is repaired. You see each one in writing before our Fairvilla team starts.
- Apron flashing across the downhill face
- Back pan or cricket on the uphill side
- Old tar, caulk and patch metal to remove
- Valleys and downspouts draining toward the chimney
Our approach to chimney flashing in Fairvilla
The details below shape the repair we recommend in Fairvilla, and each one shows up in your written estimate.
Base flashing needs height on the chimney and reach on the roof
Base flashing turns up the chimney face and runs out across the roof. BIA Technical Note 19B recommends that it extend at least 4 inches up the face of the chimney and along the roof, which gives water room to drain before it can find an edge.
Base pieces that barely clear the roofing are a frequent cause of leaks during a downpour, when the sheet of water on the roof gets deeper. We check the height of the existing base flashing on every face and recommend taller pieces when the old ones leave too little margin.
Chimney flashing on a metal roof
Metal panels grow and shrink with temperature, and their ribs change how water moves around a chimney. Flashing on these roofs usually involves a formed back piece, side pieces shaped to the panel profile and closures that seal the open ends of the ribs.
We follow the panel maker's published penetration details wherever they exist, since the wrong fastener or sealant can cause leaks at the ribs or conflict with the maker's terms. If the roofer who installed the panels offers matching trim, we coordinate with them so the chimney junction matches the rest of the roof.
When the flashing is not the source
Water at a chimney can come from several places. A cracked crown, a missing cap, thirsty brick or open mortar above the roofline can all put water inside the chimney, and it may appear right at the roofline where the flashing takes the blame.
We check those paths before recommending flashing work. If the flashing is sound and the water is coming from higher up, we tell you so and point you to the repair that addresses it. If both need work, each gets its own line so you can see what each repair is expected to fix.
Flashing records for a future buyer
A buyer's home inspector will usually comment on chimney flashing, especially when there is tar, sealant or staining in view. A written record of a proper repair answers those questions before they slow down a sale.
We give you a written summary of the work, the materials used and the faces repaired. Keep it with your house papers so a buyer or their inspector can see what was done and when. A tidy record often matters to a buyer as much as the repair itself.
Other work in Fairvilla
-
Fireplace Hearth Repair Repair the surface and support in front of the fireplace. Learn more
-
Chimney Liner Installation and Relining Plan a liner around the chimney and connected fireplace. Learn more
-
Electric Fireplace Installation Plan a clean installation around the room and power supply. Learn more
-
Stucco Chimney Repair Repair the layer beneath a better-looking finish. Learn more
-
Firebox Repair Restore the interior that contains the fire. Learn more
-
Chimney and Fireplace Inspection Know what your chimney needs before deciding. Learn more
Chimney flashing questions from Fairvilla
Still deciding? These answers help, and the inspection in Fairvilla is free.
Can you repair the flashing on just one side?
Sometimes. If the other faces are sound and the new piece can lap correctly into the old, a one-side repair can work. When a full reflash is worth considering, we price both options in writing.
How do you decide between a repair and a full reflash?
Flashing usually wears out gradually, with spreading rust, cracked sealant, lifted counter flashing edges and opening corners. One sign alone may not leak yet. When several show on one chimney, we explain whether a repair buys real time or a full reflash makes more sense, and both options go in writing.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.

