Chimney damper replacement and fireplace damper repair in Falcon Trace
Chimney damper replacement for Falcon Trace homes, fitted to your fireplace and tested through its full travel before we go.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Every damper repair item, in writing
- Damper plate, frame and seat condition
- New throat damper supplied and set
- Refractory mortar cure time before use
- Separate lines for firebox or smoke chamber work
Our approach to damper replacement in Falcon Trace
Surface rust versus rust that weakens the damper
Almost every damper has some rust. A thin orange film on a thick casting is normal and harmless. Rust that flakes in layers, leaves pits or eats holes through the plate is a different story.
Our technicians check the depth of the rust at the plate, the seat and the pivots. Light rust gets cleaned during the repair. Deep rust means replacement, and we show you where it is before you decide.
Light rust can be cleaned off and the damper protected by keeping water out of the flue. Deep rust means the metal is losing strength. We show you the difference so the decision is clear.
Save on damper repair booked within 72 hours
Any service booked within 72 hours after your free inspection is 10% off, and chimney damper replacement and repair qualify. Mention the offer when you call or add a note on the form.
The inspection and written estimate are free either way. Book within 72 hours after the inspection, and the discount shows on your estimate before any work starts.
The discount applies to every service you book within the 72 hours, so if your damper job includes a new handle or cap work, the savings cover those lines too. Our office confirms the offer when you book.
What to tell us about the damper
A few details help our technician come prepared. Tell us what the handle does, whether the fireplace is masonry or factory-built, when the problem started and whether smoke has come into the room.
If you know the fireplace brand or have the manual, mention it. For factory-built units, that can save a trip when parts need to be ordered.
It also helps to know how often the fireplace is used. A fireplace lit every week puts more heat and wear on the damper than one lit a few times a year, and that can affect the repair choice.
Damper handles and heat
Damper handles sit close to the fire, and metal handles can get hot while a fire is burning. Set the damper fully open before lighting and leave adjustments until the fire has burned down.
If your handle sits so close to the opening that it is hard to use safely, tell us. Our damper pros look at the control and explain whether a different handle or linkage would make it easier to operate.
A fireplace tool or a heat-resistant glove helps with a warm handle, but the safest approach is setting the damper before the fire is lit. We show you the correct position at the end of any damper visit.
Other work in Falcon Trace
-
-
-
-
-
-
Learn more about chimney damper repair and replacementFalcon Trace services
Chimney damper questions in Falcon Trace
Is it safe to close the damper right after a fire?
Wait until the fire is completely out and the ashes are cold. U.S. Fire Administration guidance warns against closing the damper over hot ashes, since that can push carbon monoxide into the house.
Should I pull harder on a handle that will not move?
No, stop at normal hand pressure. On a rusted damper, force tends to bend the rod, snap a pin or crack the casting, and a freeing job turns into a replacement. If the handle is already bent, the fix may still be small, since many damper parts can be replaced on their own.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.