Chimney sweep for fireplaces and wood stoves in Flamingo
Get the chimney swept before the next fire, with drop cloths down and the soot bagged and carried out.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
What your Flamingo chimney sweep includes
- Smoke shelf cleared and debris checked
- Room covered and fireplace opening sealed
- Glazed creosote treatment quoted as its own line
- Brush chosen for clay tile or stainless liner
Chimney cleaning explained for Flamingo homeowners
Clearing ash, grate and debris from the firebox
The firebox is where the sweep starts and ends. Before any brushing, our technicians remove the grate, andirons and old ash, so the floor and walls can be seen and the debris from above has somewhere clean to land.
After the flue and smoke chamber are done, the firebox gets cleaned again. The walls are brushed down, the floor is scraped and vacuumed, and any ash dump door in the floor is opened and checked. The grate and andirons are brushed off outside, so their soot stays out of the room, and go back in place last.
With the firebox clean, the firebrick and the mortar joints between the bricks are easy to see. Cracked bricks or open joints are fireplace repair work, and our crew notes them on your written estimate instead of hiding them under a fresh cleaning.
Building a fire that burns clean
A clean-burning fire starts small and hot. EPA guidance says to start fires with newspaper, dry kindling or all-natural fire starters, and never with gasoline, kerosene or charcoal starter. Add split wood once the kindling is burning well, instead of smothering it early.
Keep flammable items such as curtains, furniture, newspapers and books away from the fireplace, the same guidance says. Open the damper fully before lighting, and give the fire enough air to burn brightly instead of smoldering. A sturdy screen goes across the opening once it is lit.
A fire built this way sends less unburned smoke into the flue, and less smoke means less residue left behind. Our technicians see the difference in the deposits from one sweep to the next, and they will gladly walk you through a routine that suits your fireplace in Flamingo.
Save 10% on chimney cleaning booked within 72 hours
Any service booked within 72 hours after your free inspection is 10% off, and a chimney cleaning is a good place to use it. The discount is written onto your estimate, so you see it before you approve anything.
The offer does not change the work. The free inspection comes first, the room is protected, every part of the flue the brushes can reach is cleaned and the visual check ends the visit. The crew and the tools are the same as on any other visit. Any repair found is quoted on its own, and you decide on it on its own.
Mention the offer when you set up the visit in Flamingo. If the sweep leads to a repair you approve within 72 hours after the inspection, the 10% discount applies to it too.
A masonry chimney that now vents a gas appliance
Some masonry chimneys that once served wood fires now vent a gas fireplace or another gas appliance. The fuel has changed, but the flue can still collect debris, nests, fallen mortar or old wood-burning deposits that were never removed.
If you smell gas, do not light the appliance. Get everyone out of the home and call 911 or the gas company from outside.
Cleaning and servicing the gas appliance itself is gas fireplace work, handled under our gas fireplace service. What a sweep can do is clear the chimney above the appliance, remove a blockage and check the cap. On a converted fireplace in Flamingo, the estimate keeps the two apart, with the flue work priced under the sweep and the appliance referred to the gas fireplace service as its own job.
Other work in Flamingo
-
-
-
-
-
Learn more about chimney sweep and chimney cleaningFlamingo services
Related chimney sweep work
What homeowners ask before a sweep
What if the flue has a hard, shiny coating the brushes cannot remove?
That is glazed creosote, and it calls for a separate removal treatment applied per the product label. We quote it as its own line, and the treated material is swept out on a second visit once it dries.
Can I use the fireplace the same day it is swept?
Usually, yes, once our crew has finished and the damper has been tested. The exceptions are a glazed treatment that is still drying and a repair finding that should be settled first, and we tell you about either before we leave.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.