Family-owned stucco chimney repair in Fullers
Repair the stucco, protect the chimney and know what you paid for. Written estimates and satisfaction guaranteed in Fullers.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
What we measure on Fullers chimneys before quoting stucco
A short list that shapes the whole job. We confirm each point at your Fullers address first.
- Hollow or loose areas found by sounding each face
- Cutback of loose and cracked stucco to sound edges
- Number of coats rebuilt in each repair area
- Number of visits the coats require
Inside a stucco chimney repair in Fullers
Details our Fullers team explains on every stucco chimney visit.
Why the number of stucco coats matters
Section R703.7.2 of the Florida residential code calls for at least three coats of cement plaster over lath and at least two coats where plaster goes directly onto masonry or concrete. A repair should rebuild the same build-up it replaces.
A thin skim of patch over a lathed wall leaves the repair weaker than the stucco around it, and it tends to crack along the outline. Your written estimate states how many coats each repair area gets and what each coat does. Where the existing stucco is thicker or thinner than usual, the repair follows what is actually on the wall.
A repair mix that behaves like the old stucco
The International Masonry Institute says a stucco repair mix should come close to the old stucco in strength, density, porosity and water absorption. A mismatch in any of those shows up as cracking or staining at the patch edges.
We choose repair materials with the existing finish in mind. A mix far harder or more absorbent than the surrounding stucco may look fine at first and fail at the joint later. That is also why we avoid mixing different repair products on one face.
Protecting plants, walls and walkways
Cutting out old stucco makes dust and debris, and fresh stucco splatters. We cover plants, windows, walkways and roof areas below the chimney before starting. Gutters directly below the chimney are checked too, since stucco dust and chips tend to collect there.
Mixing happens on protected ground, and the area is cleaned at the end of each visit. That protection and cleanup are included in the price you approve. If a plant has to be tied back to reach the chimney, we ask before touching it.
Old patches that failed at their edges
Patches that were too hard, too thin or feathered over the old finish tend to crack along their outline. A ring of cracks around an old repair is a clue that it never took hold.
We remove failed patches back to sound stucco and rebuild them properly. Leaving a failed patch in place and patching around it only adds another edge for water to find. The outline of the new repair is chosen so the old failed edge is removed completely.
Other work in Fullers
-
-
-
-
Stucco chimney questions from Fullers
Straight answers from our specialists in Fullers, with no sales pressure.
Can I pressure wash my stucco chimney?
High pressure can erode the texture and drive water into cracks, so we advise against it. A gentle rinse with a soft brush is safer. Keep all washing off new stucco until it has cured.
Will my chimney need a full restucco?
Only if loose areas and failed patches cover so much of the finish that patching would not hold or would look worse. Many chimneys need only targeted repairs. When the choice is close, we price both options.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.