Gas fireplace insert installation from our Goldenrod team
Gas insert installation in Goldenrod with the opening measured, the liners run and the surround fitted clean. 100% satisfaction guaranteed.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Before we order an insert for your Goldenrod home
No product photo can tell us these things. We check them at your fireplace in Goldenrod and list them with upfront pricing.
- Plates or insulation closing the gap around the liners at the damper
- Hearth and floor covering in front of the insert
- Removal and disposal of old doors, screen and grate
- Leak check and supply pressure reading at startup
How our Goldenrod crew fits a gas insert
Each point below comes from the insert manuals and the gas code, and each one shapes your Goldenrod estimate.
Why the chimney is examined before hookup
Florida's Fuel Gas Code has a rule for exactly this job. Section 503.5.6 says that before an appliance is connected to a chimney, the passageway must be examined to confirm it is clear and free of obstructions, and cleaned if it previously vented a fireplace or another solid- or liquid-fuel appliance.
A chimney that carried wood smoke for years will almost always need that cleaning. We do it as part of the preparation, or list it on the estimate when it is a bigger job, before the insert's liners go down. A new gas appliance never gets connected to a passage that has not been cleaned and checked.
Setting the restrictor for your vent height
A tall vent pulls harder than a short one. To balance that, many inserts have a restrictor that is set by vent height. In Heat & Glo's table, the restrictor openings stay closed on shorter runs and are opened one at a time, then both, as the vertical run gets taller.
The wrong setting can leave the flame lazy or make the insert cycle on and off. We measure the finished vent height, set the restrictor to the manual's table before the first fire and watch the flame during startup.
Protecting the valve during pressure tests
Gas piping is pressure tested when it is installed, and test pressures are far higher than an insert's valve can take. Heat & Glo warns that pressure above half a psig will damage the gas valve control, and tells installers to disconnect the appliance and its shutoff valve before line pressure testing.
We coordinate the order with whoever tests the line, so the insert is isolated during the test and connected afterwards. It is one of those steps that only matters if someone forgets it.
Sealing a wall built out around the fireplace
Sometimes the fireplace face is built out with a new wall to update its look. Heat & Glo says the surround must overlap that wall extension, and that the transition to the existing masonry wall must be sealed to keep heat from escaping behind the wall.
The manual gives two ways to seal that transition, high-temperature silicone rated for 300 degrees or insulation packed into the voids between the masonry and the steel studs, and says slots in the steel studs must be sealed too. If a face-lift is part of your plans, we work out the order with you, so the insert, the new wall and the surround fit together the way the manual shows.
Other work in Goldenrod
-
-
-
-
-
-
Learn more about gas fireplace insert installationGoldenrod services
Common gas insert questions in Goldenrod
Short, straight answers from our fireplace team in Goldenrod. Anything else, just call.
Will a gas insert work during a power outage?
Many electronic-ignition inserts include a battery pack for outages, and Heat & Glo's Supreme series is one. The maker treats batteries as an emergency power source only. We show you how your model handles an outage at handover.
Can a gas insert go in a bedroom fireplace?
Florida's Fuel Gas Code bars gas appliances from bedrooms, though a direct-vent unit installed to its listing is one of the allowed exceptions. Sealed inserts are generally direct vent, but your model's manual decides. We check before recommending one.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.