Family-owned fireplace repair serving Horizon West
Our family-owned crew fixes dampers, fireboxes, hearths and doors for Horizon West homes, with upfront pricing and no hidden fees.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
What we check before quoting a fireplace repair
- Fireplace type confirmed, with the model where labeled
- Listed parts for factory-built units
- Blower parts on factory-built wood units
- Care notes for the first fire after repair
Fireplace repair from the grate to the damper
Steel fireplace units set inside masonry
Some masonry fireplaces were built around a steel fireplace unit, a factory-made steel firebox with masonry laid around it. The Florida Building Code allows these when they are installed to their listing or to the code's own section on steel units. Under that section the steel lining has an air-circulating chamber ducted to the interior of the building, and the circulating air ducts are metal or masonry.
The steel box is the part that sees the fire. When it rusts through, splits at a seam or warps, the repair depends on how the unit was installed and what its listing allows. It is not the same job as repairing firebrick.
Our crew identifies these units by the steel lining and the circulating air ducts, checks the steel and the air channels that can be reached and explains whether a repair is possible or the unit has reached replacement. All of it goes on the estimate.
Smoke drifting out of the opening
EPA wood-burning guidance says a properly installed, correctly used wood-burning appliance should make very little smoke, and that if you regularly see or smell smoke, you may have a problem. A fireplace that puffs smoke past the screen deserves a look.
If smoke starts filling the room, take everyone outside and dial 911 from there, without staying to fan the smoke or tend the fire.
Once the room is clear and the fireplace is cold, the causes are checked in order. The damper may not open fully, the passage above the firebox may be smaller than the flue, the wood may be wet, or a change to the opening, such as new doors or a narrowed opening, may have altered how air moves. Our technicians go through each one and write down which it is, with the repair that fixes it.
Raised hearths that crack or pull loose
A raised hearth lifts the fire and gives the room a seat or a ledge. It is also a box of masonry or framing with a finish on top, and those parts can separate. Cracks along the front edge, a loose top slab or a gap where the hearth meets the wall are the signs to look for.
Hearths used as seats or steps take loads they may not have been built for. The Florida Building Code asks hearths to be reinforced to carry their own weight and all imposed loads, and a raised hearth that has settled or cracked is worth checking below the surface as well as on it.
Our crew checks what the raised hearth is built from and whether the top is still properly supported. For homes in Horizon West, the repair might be a new top slab, reset stone or a rebuilt edge, and each is written up with the materials named.
Oversized fires and the parts they damage
A fire built bigger than the fireplace was made for pushes every part harder. Firebrick may crack and joints open, a steel damper may warp, door frames distort, screen mesh wears through and, in a factory-built unit, panels crack.
Big fires often come from burning scrap lumber, boxes, wrapping paper or large loads of small wood at once. EPA wood-burning guidance lists household trash, cardboard and scrap materials such as plywood among the things that should not be burned at all.
When our technicians see overheating damage, they say so plainly and repair the parts involved. The written record we leave in Horizon West includes simple guidance on fire size for your fireplace, because the next oversized fire could undo the repair. It covers the load of wood and the size of fire that suits the firebox you have.
Other work in Horizon West
-
-
-
-
-
-
Learn more about fireplace repair and serviceHorizon West services
Related fireplace repair work
-
-
-
-
Common questions about fireplace work
Should I light a fire to show you the problem?
No. Leave the fireplace cold and describe what you saw, when it happened and what the fire was like. Our technician checks it cold, which is safer, and your description fills in how the fire behaved.
Is the repair covered after you leave?
Yes. Our workmanship warranty applies to each fireplace repair, alongside our 100% satisfaction guarantee. If something we fixed does not hold up as it should, we come back and put it right.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.