Skip to content

Proudly American | Family owned

Same-day service available

(352) 675-6376 Book Online

Gas log installation, vented or vent-free, in Lake Mann Estates

Honest gas log advice from local experts. We tell you what your fireplace can take, what it cannot and what it costs before any work.

  • Licensed & insured
  • Locally run
  • Family owned and operated
  • Same-day service available
4.8 out of 5 from 736 reviews
  • Google
  • Yelp
  • Facebook

Log set details we put in writing in Lake Mann Estates

A firebox cannot be sized by eye from across the room. We measure it on site in Lake Mann Estates during the free inspection.

  1. Minimum damper opening from the set's table
  2. Sand or vermiculite matched to the gas type
  3. Outside air ducts or clean-out doors closed if required
  4. Lighting and shutdown shown to you

Before a log set goes into your Lake Mann Estates fireplace

Our Lake Mann Estates installers go over points like these with every homeowner before ordering.

The kind of fireplace a vented log set needs

A vented gas log set is built to sit in a real wood-burning fireplace. One maker's manual says its set may be installed only in a wood-burning fireplace built of noncombustible material, with a flue that works, with combustion and ventilation air provided as the national fuel gas code requires.

That rules out decorative openings, fireplaces with no flue and boxes built from combustible material. Our pros confirm the fireplace type, the flue and the construction before any set is recommended.

Noncombustible facing above a vent-free set

A vent-free set sends hot air up the face of the fireplace. Without a mantel, one manual requires noncombustible material such as slate, marble or tile, at least 1/2 inch thick, above the fireplace opening, and sheet metal only with noncombustible material behind it.

Painted drywall or wood trim right above the opening does not meet that rule. Our pros check the facing and explain the fix, whether that is new facing, a hood accessory or running the set vented with the damper open.

Protecting the set during a pressure test

Gas piping gets pressure tested when it is installed or altered, and log set valves are not built for test pressure. One maker says the set and its main valve must be disconnected from the piping during any test above 1/2 psig.

For tests at or below 1/2 psig, the same manual says the set must be isolated by closing its equipment shutoff valve. Our technicians coordinate with the gas contractor so the set is protected whenever the line is tested.

Checking pressure with every appliance running

A log set shares its gas line with the water heater, the dryer, the range and sometimes a pool heater. One maker notes that other gas appliances on the same line may drop the pressure reaching the log set and asks for pressures to be checked with everything operating.

Our technicians do that test when a set runs well alone but shrinks or shuts down when the house is busy, and they explain whether the fix belongs to the log set or to the supply.

A log set that has been under water

Flood water ruins gas controls. One vented set manual says a set with any part that has been under water stays off until a qualified service technician has inspected it and replaced every part of the control system and every gas control that got wet.

The same manual warns that attempted operation may result in fire or explosion. Our technicians follow that rule even when a wet set seems to light, and they list the replacement parts on a written estimate.

Gas log answers for homeowners in Lake Mann Estates

Answers to what Lake Mann Estates homeowners ask us about gas logs, from our family-owned team.

Will gas logs work in my fireplace?

Only if the fireplace qualifies. One vented log set manual limits its burner to a wood-burning fireplace built of noncombustible material with a flue that works. In a factory-built fireplace, the fireplace's own manual has to allow the set. We check both at the free inspection.

Why does the damper have to stay open with gas logs?

The exhaust from a vented set rises up the chimney, which means the flue has to stay open. One maker ships a clamp that is fixed to the damper for good and wants the damper fully open any time the set is lit. Vent-free sets have their own rules in their own manuals.

Request your free estimate

Share the job details and arrange a free inspection with our local team.

  • Free inspection
  • No hidden fees
  • Family owned and operated

Need an answer now? Call (352) 675-6376

Tell us what needs attention. We will contact you to arrange your free inspection.

Call(352) 675-6376