Chimney chase repair and rebuilding in Lake Weldona
Local, family-owned chase repair in Lake Weldona, backed by our workmanship warranty and no hidden fees.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Chase repair scope for your Lake Weldona home
- Moisture readings across each face of the chase
- Replacement siding matched to the existing profile
- Stucco rebuilt in three coats over new lath
- Firestops, shields and pipe supports reset as listed
Chimney chase repair from the top plate down
Corrosion-resistant flashing and fasteners
Flashing and fasteners on a chase sit against wet wood and damp air, year after year. Under the Florida Building Code, metal flashing has to be corrosion resistant, both on walls under R703.4 and at roof intersections under R903.2.1. Stucco lath and its attachments have to be corrosion resistant too, under R703.7.1.
Plain steel nails and bare steel flashing can rust, stain the siding and lose their hold. A rusty streak below a nail head is often the first mark you notice on painted siding. Once a nail rusts through, the siding it held starts to move and the hole it leaves lets in water.
Our crew uses corrosion-resistant fasteners and flashing made for exterior work, and follows the siding maker's fastener instructions where they are more specific. Your Lake Weldona estimate names the flashing material, so you know what went into the wall.
Three coats of stucco over lath
Stucco on lath is built up in coats. The first, called the scratch coat, is pressed into the lath and scored. The second, the brown coat, builds thickness and flattens the wall. The finish coat carries the texture and color.
Under R703.7.2 of the Florida Building Code, cement plaster over lath goes on in at least three coats. Two coats are allowed directly over masonry, which is why a patch copied from a block wall can end up too thin on a framed chase. It is also why a patch on a chase needs the same full build as a new wall.
A patch built too thin is more likely to crack and let water reach the barrier. When our crew patches or reclads a chase, we build the full three coats and match the finish to the rest of the wall. Your Lake Weldona estimate names the stucco system and the number of coats.
Letting each stucco coat cure before the next
Stucco gains strength as it cures, and the Florida Building Code sets minimum waits between coats. Under R703.7.4, each coat is kept moist before the next one goes on. Under R703.7.5, the finish coat on three-coat work goes on no sooner than seven days after the second coat. Both sections make an exception for work installed per ASTM C926.
Those waits are why a stucco chase repair takes more than one visit. The scratch coat is scored so the next coat grips, and the chase stays covered between visits. On hot or windy days, keeping a fresh coat moist takes more attention, so the crew plans that work for the cooler part of the day where it can.
We plan the schedule around curing time and tell you how many trips the job takes before it starts. The fireplace stays out of use until the wall is closed and the top is sealed, and the timing is part of the written estimate.
Interior drywall and paint after a chase leak
A leaking chase often leaves damage inside the house, in the ceiling beside the fireplace, the wall next to it or a closet the chimney passes through. That drywall and paint can only be fixed after the leak is stopped and the wall has dried out. Stains on painted ceilings tend to bleed back through ordinary paint unless a stain-blocking primer goes on first.
Fixing the inside first means doing it twice. Drywall that stays damp behind fresh paint can stain again and grow mildew.
Our crew stops the leak and repairs the chase, then checks the interior area for moisture before it is closed up. A moisture meter on the drywall decides that, not a guess. Interior repairs appear on their own line, and if you prefer your own painter, we tell you when the wall in your Lake Weldona home is ready for them.
Other work in Lake Weldona
-
-
-
Chimney chase repair questions in Lake Weldona
Can a chase be changed from siding to stucco?
Yes, as long as the framing is sound and flat. Stucco over wood needs a two-layer barrier, corrosion-resistant lath and three coats, so we price it as its own option next to a like-for-like siding repair.
What happens to the chimney pipe while you work on the chase?
The pipe stays in place and is protected while the framing around it is replaced. Our crew keeps the listed air space clear and puts firestops, shields and supports back where the chimney maker's instructions call for them.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.