Electric fireplace installation planned around your Lake Whippoorwill room
On the wall, recessed or in an old firebox, our Lake Whippoorwill pros install it cleanly. Take 10% off when you book within 72 hours after your inspection.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
What we measure in Lake Whippoorwill rooms before install day
A short list with a big effect on the result. We confirm each item at your Lake Whippoorwill address before any cutting.
- Heater outlet direction and what sits above it
- Closing drafts and openings behind an insert
- Controls, remote and wall switch setup
- Manual, model and serial number kept for your records
What goes into an electric fireplace install in Lake Whippoorwill
Two parts of the job our fireplace specialists explain to homeowners in Lake Whippoorwill before install day.
When a dedicated circuit is required
Manuals differ on circuits. Dimplex's IgniteXL linear fireplace manual calls for a dedicated, properly fused 15 amp circuit rated for the unit's voltage. The manual for its plug-in XHD firebox says a dedicated circuit is preferred but not essential, and becomes necessary if the breaker trips regularly when the heater runs.
So we never assume. Our crew reads your model's requirement and checks what else shares the circuit you plan to use. If a dedicated circuit is needed, it goes on the estimate as electrical work, done by an electrician, so the fireplace runs its heater without tripping anything.
The heater outlet must stay open
The heater in an electric fireplace pushes warm air out of an outlet, often a slot above or below the flame. Makers warn that the trim around it becomes hot and that the front of the heater must never be partly or fully covered.
We plan everything nearby around that outlet: mantels, shelves, decor and the TV. Before we leave, we run the heater and check that the outlet is clear. If you later add a mantel or decor, check the manual or call us so the outlet stays unobstructed.
Storing the unit before install day
Makers suggest keeping the fireplace in a safe, dry, dust-free place until installation and leaving the front glass in its box until you are ready to fit it. A unit left in a dusty renovation zone can collect grit in its heater and flame parts.
If your project involves drywall sanding or tile cutting, we plan the fireplace delivery or unboxing for after the dustiest work is done. The unit goes in clean, and the glass goes on last, so nothing gets scratched or clouded.
When the studs are in the wrong place
Studs do not always line up with where you want the fireplace centered. The bracket may need blocking added inside the wall, or the fireplace may shift slightly to land on framing.
We show you the options before drilling. Adding blocking means opening and patching the wall, which is listed on the estimate. Shifting the unit is free but changes the look. Either way, you decide with the facts in front of you.
Other work in Lake Whippoorwill
-
-
-
-
- Fireplace RestorationBring an unused fireplace back with a coordinated plan.
- Ventless Gas Fireplace ServiceService the unit within its exact installation limits.
Learn more about electric fireplace installationLake Whippoorwill services
What people in Lake Whippoorwill ask about electric fireplaces
Short answers from our fireplace team in Lake Whippoorwill. Call for anything not covered here.
Can you put an electric insert in my old fireplace?
Yes, in most sound, dry fireboxes. We measure the opening, remove old doors or grates, close drafts behind the insert as its manual directs and bring power to it. A trim kit then finishes the face.
Do I need to be home during the installation?
It helps to be home at the start and for the walkthrough at the end. That is when we confirm the height and position and show you the controls. In between, we just need access to the room and the breaker panel.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.