Gas fireplace insert installation from our Maitland team
Gas insert installation in Maitland with the opening measured, the liners run and the surround fitted clean. 100% satisfaction guaranteed.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Measured at your Maitland fireplace, priced in writing
Our installer takes a tape, a light and the insert manual to your Maitland fireplace. These are the kinds of items that come back in writing.
- Firebox width, height and depth against the insert's minimum opening
- Outlet inside the firebox or a cord route to a nearby outlet
- Leak check and supply pressure reading at startup
- Workmanship warranty and the 72-hour 10% discount shown on the estimate
The engineering behind a gas insert in Maitland
Field notes from our gas insert installers serving Maitland.
Keeping insulation off the vent
The vent carries hot exhaust, and the manual is firm about the space around it. Heat & Glo warns installers not to pack the air space around the vent with insulation or other materials, because that can lead to overheating and fire.
At the damper, we use only the non-combustible material the manual allows, in the way it allows it. Everywhere else, the liners run through the open chimney with the clearance their instructions give them.
A gas line sized for the insert
The right size of gas line depends on its length, the other appliances on it and the insert's input. The Supreme manual tells installers to check local codes and gas line sizing requirements following NFPA 54 before connecting.
If your fireplace already has a gas line, nobody should assume it suits the new insert. We check its size and condition first. If it needs to change, the change is on the estimate with the gas professional's name beside it.
Ember material, placed by the diagram
Glowing ember material adds to the look of a gas fire, and it has rules too. The Supreme manual says embers cannot be placed over marked burner ports or in the pilot area, must be laid loosely in a single layer no more than a quarter inch thick, and should be replaced annually.
Too much ember, or ember pressed into the ports, causes lighting trouble and soot. We place it by the diagram and leave the spare material with you for the yearly service.
Moisture on the glass at startup
Water droplets on the inside of the glass when the insert first lights are a normal result of burning gas. Heat & Glo's owner's manual adds a point for summer: warm, humid outdoor air inside the firebox can condense on glass that air conditioning has cooled below the dew point.
The moisture clears as the glass warms. We mention it at handover, so nobody mistakes it for a crack or a fault on a muggy evening.
Other work in Maitland
-
-
-
-
-
-
Learn more about gas fireplace insert installationMaitland services
Quick gas insert answers for Maitland
Short, straight answers from our fireplace team in Maitland. Anything else, just call.
Can I still burn wood after a gas insert is installed?
No. The converted fireplace is labeled for gas insert use only. Going back to wood means removing the insert and its liners and having the fireplace and chimney approved again.
Do I have to remove my mantel for an insert?
Not if it meets the insert's clearance table. We measure its height and depth against the table for your model. If it falls short, we explain the choices before anything is ordered.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.