
Chimney crown repair in Mariners Village
We seal fine cracks or cast a new sloped crown, then show you the finished work. Free inspection and 10% off when you book within 72 hours after it.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
What your crown estimate covers in Mariners Village
- Forms, reinforcement and a new cast crown
- Roof protection below the work area
- Cure time before the next fire
- Water staining on the chimney face below
The crown work behind a dry chimney
An overhang that throws water clear of the brick
A good crown sticks out past the face of the chimney. That overhang, with a drip formed under its edge, makes rain fall off instead of curling back and running down the brick. Without it, the top courses of masonry stay wet after every storm and wear out years early.
When we rebuild a crown, the overhang and drip are part of the form work from the start. If your current crown sits flush with the brick, the inspection notes it, and our technician explains what a new edge would change for the masonry underneath.
An overhang also protects the mortar joints in the top courses, which are the first to wash out when water runs down the face. Keeping those joints dry means fewer masonry repairs later, which is why our crew treats the edge of a new crown as part of the repair and never as trim.
Crowns that cover more than one flue
A chimney that serves two fireplaces, or a fireplace and another appliance, has several flues coming up through one crown. Each flue needs its own bond break and sealant joint, and the crown has to slope away from all of them at once.
Multi-flue crowns take more form work and more care around each liner. Our crew checks every flue tile for cracks and height before pricing the job. The estimate lists the flues by location, so you know each one was looked at.
Flues also differ in height and condition. One tile may be cracked while another is fine, or one flue may no longer be used. We note each one so the crown plan fits the chimney as it is, and any flue repairs appear as separate lines you can decide on.
Crown leaks versus flashing leaks
Flashing seals the joint where the chimney passes through the roof, and the crown seals the top. A leak at either spot can end up inside, but they usually show in different places. Flashing leaks tend to stain the ceiling or wall beside the chimney, while crown leaks show inside the flue or firebox.
Brick Industry Association guidance treats chimney flashing and the chimney top as separate details, and so do we. Our technicians check both and tell you which one is leaking. If both are, you see both on the estimate with their own prices.
Sometimes the answer is both, and the order matters. The crown usually gets fixed first because it sits at the top, and water from it can confuse any test of the flashing. Once the top is dry, a remaining leak points clearly at the roof joint.
A rusty damper that starts at the crown
When the damper plate rusts shut or the firebox floor shows orange stains, water is reaching the inside of the chimney. A cracked crown is often how the water gets there.
We look at the top first when the damper is rusty, because repairing the damper without stopping the leak just brings the rust back. The estimate lists the crown work and any damper work separately, and you decide the order.
A damper rusted by crown leaks can sometimes be freed and cleaned once the water stops. If it has rusted through, it needs replacing. Our technician checks the damper during the crown inspection and tells you which situation you have.
Other work in Mariners Village
-
Wood-Burning Fireplace Insert Installation Fit a wood insert to a suitable existing fireplace. Learn more
-
Top-Sealing Damper Installation Choose a top damper only when the fireplace allows it. Learn more
-
Chimney Masonry Repair Restore the masonry that holds your chimney together. Learn more
-
Electric Fireplace Repair Diagnose the controls, display and heat separately. Learn more
-
Gas Fireplace Repair and Service Get a clear answer when your gas fireplace will not cooperate. Learn more
Learn more about chimney crown repairMariners Village services
Crown repair questions we hear often
Does a new crown come with a new cap?
Not automatically. If your cap is rusted or loose, we list a cap replacement as its own line so you can decide. When both are done together, the cap is fitted after the crown has cured enough to take fasteners.
Is the crown inspection really free?
Yes. The inspection and the written estimate are both free, and whether to book is your decision alone. You keep the estimate either way.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.

