Family-owned wood fireplace installation in Monterey
A new fireplace planned from the roof down by our local family-owned team in Monterey, starting with a free inspection.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Measured on your Monterey roof and walls, then written down
None of this comes from a showroom. Our installers confirm it on site during the free visit.
- Air space kept around the fireplace and chimney
- Noncombustible face finish chosen with you
- Glass doors and screen from the approved list
- Your 10% off for booking within 72 hours, written on the estimate
Before any wall is opened for a fireplace in Monterey
Explained by the crew that frames and pipes fireplaces in Monterey.
Glass doors that belong to the listing
Section R1004.5 says a gasketed fireplace door shall not be installed on a factory-built fireplace unless the fireplace system has been specifically tested, listed and labeled for such use in accordance with UL 127. The E-series manual lists the door models tested with its fireplaces.
Aftermarket doors that seal tightly can trap heat the fireplace was not tested for. We order doors from the manual's list, and if you already bought a set, we check the model before hanging it.
The ten-foot rule for a masonry chimney
The termination rule in section R1003.9 covers masonry chimneys too, so the top stands 3 feet or more over the roof penetration and 2 feet or more over anything on the house within 10 feet.
For a masonry chimney, extra height means extra brick, extra weight on the footing and taller scaffolding. We work it out at the planning stage, so the chimney's final height is agreed before the first course is laid and the footing is sized for it.
Counting chimney sections before ordering
A factory-built chimney is ordered as a parts list: straight sections, any offsets and their straps, a firestop for each floor or ceiling, an attic shield, the roof parts, a storm collar and the listed cap. The count comes from floor heights, attic depth, roof pitch and the ten-foot rule.
We measure each of those at the planning visit and build the list from them, with a little margin where the manual allows. That way the crew arrives with the right chimney for your house and no second trip to the supplier.
What drives the cost of a new fireplace
The biggest cost drivers are the type of fireplace, the length and route of the chimney, the roof and chase work, the hearth and face finish, and whether an old unit has to come out first. Permit and electrical work add their own lines.
We explain each driver for your project at the free inspection and put them in writing with upfront pricing, so you can adjust the plan knowing which choices move the total. Sometimes a different wall or a shorter chimney route changes the number more than a different fireplace does.
Other work in Monterey
-
-
-
-
-
Asked by Monterey homeowners before a fireplace goes in
What people in Monterey ask us before a fireplace is ordered.
Why can the chimney not take any path it likes to the roof?
Section R1005.7 holds a factory-built chimney to 30 degrees from vertical at most, with four elbows as the limit for the whole run. If a spot in the room would break either limit, the spot moves. We draw the route before recommending where the fireplace should sit.
Is a smell during the first few fires normal?
For a short while, yes. The early fires cure the paint and the materials inside the firebox, and most manuals ask for a run of smaller fires first. We light the first one with you, watch the draft with the doors open and shut, and suggest a window open while the curing finishes.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.