Roof-to-chimney flashing repair in Oakland
Same-day service available in Oakland. We trace the leak to its face, repair the flashing and leave the roof tidy.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Inside your chimney flashing quote in Oakland
What we look at face by face in Oakland, so the repair you approve is the repair the chimney needs.
- Tile to lift and reset, on tile roofs
- Exposed fasteners and old mounting holes
- Sealant products and where each one goes
- 10% off within 72 hours after the inspection, shown in writing
Our approach to chimney flashing in Oakland
Three parts of the job our flashing specialists explain to homeowners in Oakland before any metal is ordered.
When a chimney is wide enough to need a cricket
A cricket, which some roofers call a saddle, is a little ridged roof framed on the uphill side of the chimney so water parts around it. Section R903.2.2 of the Florida Building Code, Residential, calls for a cricket or saddle on the ridge side of any chimney more than 30 inches wide, measured perpendicular to the slope.
We measure the chimney and tell you whether it falls under that rule. Building or rebuilding a cricket is its own job with its own framing and roofing, so when one is missing or failing we write it up on a separate line, next to the flashing repair it connects to.
What the attic side can reveal
The attic side of a chimney often tells the clearest story. Dark rings on the roof decking beside the chimney, damp framing or tracks down the chimney's outer face point to the junction directly above.
When there is attic access near the chimney, we ask to look there as part of the free inspection. We note which side shows moisture and whether the marks look active or old. That observation decides which flashing faces get the closest look up on the roof.
The mark indoors is a separate repair
Stopping water at the flashing does not remove the mark it left on the ceiling or wall. Drywall and paint need to dry fully before the finish is repaired, and staining can bleed through fresh paint unless the area is sealed first.
Interior repair sits outside our flashing scope unless we agree to it in writing. We suggest waiting through a few rains after the repair to confirm the area stays dry before repainting. If a new mark appears, note the date and weather and call us, and we will compare it to the original.
Flashing bent to fit your chimney
Chimney flashing is usually formed from flat sheet on a brake, bent to the angles and widths each face needs. Stock pieces can work on the sides, but aprons, corners and back pans often have to be shaped to the chimney in front of us.
We measure each face and form the pieces to fit instead of forcing stock parts into place. A close fit at the corners and bends means less reliance on sealant to close gaps, and a cleaner look from the ground.
Other work in Oakland
-
-
-
-
-
-
What people in Oakland ask about chimney flashing
Short answers from our chimney team in Oakland. Call for anything not covered here.
Will another coat of caulk stop my flashing leak?
Rarely for long. Sealant belongs inside a proper flashing detail, but spread over an open gap it hardens and pulls away from the masonry. We repair the metal and the joint that holds it.
What metal do you use for chimney flashing?
It depends on the roof covering and the chimney face. We commonly work with aluminum, coated steel, stainless and copper, and the Florida code requires the metal to be corrosion resistant. The metal and its thickness are written into your estimate.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.