Family-owned chimney flashing repair in Piedmont
Repair only what failed and know what you paid for. Written estimates and satisfaction guaranteed on flashing work in Piedmont.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
What we check on Piedmont roofs before reflashing
These are the details that decide how the flashing is repaired. You see each one in writing before our Piedmont team starts.
- Roofing lifted around the chimney and how it goes back
- Tile to lift and reset, on tile roofs
- Chimney width against the code's cricket rule
- Cleanup and haul-away of old metal
How we handle chimney flashing repair in Piedmont
The details below shape the repair we recommend in Piedmont, and each one shows up in your written estimate.
Chimneys on low-slope and flat roof sections
Low-slope roof sections keep water around a chimney longer after every storm. Membrane roofs use their own flashing methods, often the membrane turned up the chimney and covered by metal counter flashing anchored in the masonry.
Our part at that junction is usually the chimney side, meaning the counter flashing and the masonry it anchors into. Where the membrane itself needs work, we say so and explain how the two scopes meet, so neither trade leaves an open edge at the top of the other's work.
Fastening step flashing to the roof, not the chimney
The roof and the chimney move independently. The chimney stands on its own foundation, while the roof framing shifts with heat and moisture. Flashing that is nailed to both can tear as they move.
That is why step and base pieces are fastened to the roof deck and covered by counter flashing that is fixed to the chimney. The two layers overlap without being tied together. We check how the existing pieces were fastened and correct any that pin the roof and chimney to each other.
Painting flashing to match the chimney
Some homeowners want the flashing painted to match the brick, the stucco or the roof. Paint can protect certain steels and make the junction less noticeable from the street, but it must suit the metal and go on a clean, prepared surface.
We tell you which flashing metals take paint well and which are better left bare. If you choose paint, the product and color are recorded in your scope so the finish can be matched later.
Flashing cement and where it fits
Flashing cement is a thick roofing compound used to bed and seal flashing laps. It appears in the prescribed L flashing option of Section R905.2.8.1 of the Florida Building Code, Residential, where the laps between pieces are sealed in flashing cement.
Used that way, it supports the metal. Spread across the surface as the only barrier, it dries, cracks and leaves the seam open. We use it inside the detail as the method calls for and never as a substitute for missing metal.
Other work in Piedmont
-
-
-
-
-
Chimney flashing questions from Piedmont
Still deciding? These answers help, and the inspection in Piedmont is free.
What happens to the stain indoors after the flashing is fixed?
The mark stays until the interior is repaired. Let the area dry through a few rains before repainting, and seal it first so it does not bleed through. Call us if it grows.
How do you decide between a repair and a full reflash?
Flashing usually wears out gradually, with spreading rust, cracked sealant, lifted counter flashing edges and opening corners. One sign alone may not leak yet. When several show on one chimney, we explain whether a repair buys real time or a full reflash makes more sense, and both options go in writing.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.