Fireplace repair with a free inspection in Princeton/Silver Star
Your Princeton/Silver Star fireplace, checked from grate to damper and repaired with parts that suit it.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Fireplace repair items we put in writing for Princeton/Silver Star
- Refractory panels in a factory-built firebox
- Lintel over the opening and where it bears
- Screen mesh, rods and rings
- Blower parts on factory-built wood units
Fireplace repair from the grate to the damper
Gaps opening up between the firebricks
The joints between firebricks are meant to be thin. The Florida Building Code limits them to no more than a quarter inch. When joints wear back, crack or fall out, the lining loses the tight surface the code describes and loose bricks can start to shift in the wall.
We probe the joints to find the soft ones, rake them out and refill them with medium-duty refractory mortar. Where bricks have loosened, they are taken out, cleaned and reset. Joints on the room side of the fireplace, outside the firebox, are a separate job and may call for a different mortar.
The estimate shows how much of the firebox needs new joints, so you can see whether the job is a spot repair or new joints across the whole lining. Any bricks that need resetting are listed on their own line.
Smoke drifting out of the opening
EPA wood-burning guidance says a properly installed, correctly used wood-burning appliance should make very little smoke, and that if you regularly see or smell smoke, you may have a problem. A fireplace that puffs smoke past the screen deserves a look.
If smoke starts filling the room, take everyone outside and dial 911 from there, without staying to fan the smoke or tend the fire.
Once the room is clear and the fireplace is cold, the causes are checked in order. The damper may not open fully, the passage above the firebox may be smaller than the flue, the wood may be wet, or a change to the opening, such as new doors or a narrowed opening, may have altered how air moves. Our technicians go through each one and write down which it is, with the repair that fixes it.
How close wood trim can sit to the opening
Mantels and wood trim look natural around a fireplace, but the Florida Building Code limits how close combustible trim can sit to a masonry fireplace opening and how far it may project the nearer it gets. A mantel that was lowered, or trim added during a remodel, can end up closer than the code allows.
Signs of trouble include scorch marks, finish that has darkened or blistered near the opening, or trim that feels hot during a fire. Any of those is a reason to measure before the next fire.
We measure from the opening to each piece of wood and compare it with the code for masonry, or with the manual for a factory-built unit. If something sits too close, the estimate lists the options, such as moving the mantel, trimming back a projection or replacing the wood near the opening with a noncombustible piece.
The yearly look NFPA 211 calls for
NFPA 211, the standard for chimneys, fireplaces and vents, sets a check at least every year of whether they are sound, clear of deposits and correctly spaced from combustibles, with cleaning, upkeep and repair wherever the check shows a need. NFPA heating safety tips and the U.S. Fire Administration give the same yearly advice.
A yearly look catches the faults a fireplace repair deals with, a joint that has opened, a damper that has started to stick, a screen with a hole, while they are still small and cheap to fix.
For homes in Princeton/Silver Star, our fireplace maintenance visit follows that yearly rhythm. We check the fireplace itself, note anything that needs repair and point you to our chimney sweep or chimney inspection service when the flue is due. The findings arrive in writing, and nothing is repaired without your approval.
Other work in Princeton/Silver Star
-
-
-
-
-
Learn more about fireplace repair and servicePrinceton/Silver Star services
Related fireplace repair work
-
-
-
-
Fireplace repair questions in Princeton/Silver Star
Is the fireplace inspection really free?
Yes. There is no charge for the inspection or the written estimate, and no work goes ahead unless you want it to. If you go ahead within 72 hours after the inspection, you save 10%.
Is the repair covered after you leave?
Yes. Our workmanship warranty applies to each fireplace repair, alongside our 100% satisfaction guarantee. If something we fixed does not hold up as it should, we come back and put it right.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.