Chimney step and counter flashing repair in Rio Pinar
Flashing fitted, lapped and anchored to your chimney, with a free inspection first. Our local family-owned team serves Rio Pinar with upfront pricing.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Line by line, your flashing proposal in Rio Pinar
Your written scope in Rio Pinar starts with these checks and shows 10% off if you book within 72 hours after the inspection.
- Apron flashing across the downhill face
- Back pan or cricket on the uphill side
- Crown, cap and brick checked as other water paths
- Cleanup and haul-away of old metal
Getting the flashing right on Rio Pinar chimneys
Our team in Rio Pinar walks every homeowner through points like these.
Reusing sound counter flashing
Not every flashing repair replaces every piece. Counter flashing that is well anchored in its joint, free of rust holes and long enough to lap the base properly can sometimes stay put while the base or step pieces beneath it are renewed.
We test the anchoring and look at the metal edge by edge before recommending reuse. If it stays, the estimate says so and says why we trust it. If the joint holding it has failed, we explain why reusing the metal would only move the leak a few inches.
When the mortar holding the flashing gives up
Counter flashing is only as secure as the joint it sits in. When that mortar crumbles, the metal loosens, lifts at its top edge and lets water run straight down behind it.
Re-sealing the edge without repairing the joint rarely lasts. We rake out the failed mortar, reset or replace the counter flashing and repoint the joint so it grips the metal again. If mortar across the rest of the chimney is failing too, we tell you and quote that masonry work on its own line.
Roof pitch, height and access
How the crew reaches the chimney affects the time, equipment and care the job needs. A steep pitch, a two-story eave or a chimney tucked between rooflines calls for more setup than a low, gentle roof.
We assess access during the free inspection and explain what equipment will be used and where ladders will stand. If plantings, screen enclosures, solar panels or skylights sit near the work, tell us so the plan protects them from the start.
A chimney beside a taller wall
When a chimney sits against a second-story wall, the flashing has to work with the wall's weather barrier and cladding as well as the roof. Water running down the wall and down the chimney can meet at the same inside corner.
We check that the flashing at that corner turns water onto the roof and away from the wall. Repairs here can involve cladding, so we explain how much is disturbed and how it is restored before any work starts.
Other work in Rio Pinar
-
-
-
-
-
Flashing repair answers for Rio Pinar homeowners
Our family-owned team in Rio Pinar answers the questions that come up most on flashing jobs.
Why is chimney flashing made in two parts?
Base flashing is fastened to the roof and counter flashing to the chimney, and the lap between them lets each move a little without tearing a seam. BIA Technical Note 19B treats them as separate pieces for that reason. One-piece metal run from the roof into a mortar joint cannot flex, so we replace it with a two-part detail.
Can the new flashing be painted to match?
Some metals take paint well and some are better left bare, and paint only holds on a clean, prepared surface. We tell you which is which for your flashing. If you choose paint, the product and the color go into your written scope, so the finish can be matched later.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.