Chimney chase repair with a written estimate in Riverside Acres
Protect the chimney inside your chase. Free inspection, upfront pricing and 10% off in Riverside Acres when you book within 72 hours after it.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Chase work written up for Riverside Acres homeowners
- Rotted studs, plates and corners replaced or sistered
- Seam and flashing where the chase meets the house
- Paint on new siding and trim
- Added work priced in writing before it starts
Our approach to chase repair in Riverside Acres
Peeling paint and what it says about the wall
Paint peeling off a chase is more than a cosmetic problem. Paint tends to fail from behind, when water in the wood or sheathing pushes it off. Blisters and peeling that come back soon after repainting point to water getting in somewhere. On a chase, peeling tends to start at the base, under trim ledges and just below the top.
Painting over a wet chase traps the moisture and hides the rot for another season. The next coat often fails sooner than the last one did. It also makes the next repair harder to read, because fresh paint hides the stains that show where water has been.
Our crew probes the wood behind any peeling area before recommending paint. If the wood is sound, prep and paint are enough. If it is soft, we find the water path and repair the wall first, then paint. Your written scope in Riverside Acres says which case you have.
Decorative shrouds on top of the chase
A decorative shroud is a metal housing set over the chimney termination to dress up the top of a chase. It looks good, but it also changes what surrounds the top of the chimney. R1005.2 allows decorative shrouds at the termination of a factory-built chimney only where the shroud is listed and labeled for that specific chimney system.
An unlisted shroud can also hold water or debris on the chase top, right above the framing we are there to repair. A shroud also has to come off for any work on the top framing, so its fasteners and condition get noted.
When a chase with a shroud is repaired, our crew looks for a listing label that matches the chimney. If there is none, we explain the code limit and your options, from removing it to a listed replacement from the chimney maker. Whatever you choose, the shroud is priced as its own line and dealt with before the top framing is closed.
Reading the chimney label before repairs start
Factory-built fireplaces and chimneys are listed and labeled, and the label names the maker, model and listing. Under R1004.1, factory-built fireplaces are tested to UL 127 and installed per their listing. R1005.3 ties factory-built chimneys for solid-fuel appliances to UL 103, and R1005.4 has chimneys for factory-built fireplaces meet UL 127.
The instructions that go with those labels decide the clearances, shields and supports inside your chase. The fireplace label is often inside the firebox opening or behind a panel, and original paperwork helps if you still have it. The chimney pipe itself may also carry a label on a section near the top of the chase.
Our technicians record the maker and model at the first visit, so the chase work follows the right instructions. If a label is missing or unreadable, we tell you how that limits the repair plan. This step comes before any framing is cut on a chase in Riverside Acres.
Tree limbs rubbing against the chase
A limb that brushes a chase in the wind scrapes paint, loosens siding and can knock the cover out of line. Leaves and needles pile up on the roof behind it and hold water at the base. Shade from a tree also keeps one face of the chase damp longer after rain.
Trimming limbs back from the chase and the roof is one of the simplest ways to protect a repair. It also cuts down the leaves and needles that pile up behind the chase and the animals that use limbs as a bridge to the roof.
During the inspection, our technicians note any limbs that reach the chase and any damage they have done. We do not cut trees, but your Riverside Acres estimate says which branches should come back before or after the repair, so your tree service knows what to do.
Other work in Riverside Acres
-
-
-
- Stone Chimney RepairKeep stone repairs suited to the existing masonry.
- Prefab and Zero-Clearance Fireplace RepairRepair the fireplace according to its model.
- Ventless Gas Fireplace ServiceService the unit within its exact installation limits.
Learn more about chimney chase repairRiverside Acres services
Your chase repair questions, answered
What happens to the chimney pipe while you work on the chase?
The pipe stays in place and is protected while the framing around it is replaced. Our crew keeps the listed air space clear and puts firestops, shields and supports back where the chimney maker's instructions call for them.
Is there a 10% discount for chase work?
Yes. Chase repair booked within 72 hours after your free inspection is 10% off. Mention it when you book so it is applied to your chase work.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.