Propane and natural gas fireplace repair in Roosevelt Park

The flame safeguard shuts the gas off on purpose

The fuel gas code requires vented gas fireplaces, fireplace heaters and log sets other than the manually lighted kind to carry a flame safeguard device. Its job is narrow. When the means of lighting the main burner stops working, it shuts off the gas to that burner automatically.

So a fireplace that shuts down after its pilot fails may be doing exactly what it was built to do. On a standing pilot, the thermocouple and the pilot safety in the valve do this job, while on an electronic pilot the flame sensing rod and the module do it. Another maker's wiring page warns that incorrect wiring can override the safety lockout on its electronic pilot and may cause an explosion.

The repair is to find why the pilot or its sensing failed, and that cause is what goes on the estimate. We do not jump or bypass a safeguard to get a flame going in your Roosevelt Park home. The code asks for repairs that keep the listing, and one maker counts modification of the appliance among the actions that void its warranty.

Logs set by the maker's diagram

A gas log set is not arranged by eye. Each maker prints a diagram, and the logs sit on pins, in notches and on flat spots exactly as shown. In one insert's diagram, the first log has a cutout that fits over the pilot hood, and another log is set on the burner between two pins with a note to make sure it is not covering any ports.

The positions control where the flames touch. A log turned or shifted during cleaning can block ports, crowd the pilot or put the flame against a log surface, which can lead to soot and lighting trouble. That installation manual also lists improper positioning of the gas logs among the actions that void its warranty.

In your Roosevelt Park home, each log is identified against the parts list and the set is put back to the diagram for your model before the flame is checked. Missing or mismatched logs are named on the estimate.

A blower that will not run

The fan in a gas fireplace is a separate system from the flame. One maker's millivolt direct vent manual says the fireplace works without any electrical supply and that electricity is only needed to operate the blower. A fire that lights normally therefore says little about why the fan in your Roosevelt Park home is silent.

Some fans are meant to wait. Heat & Glo's remote guide explains that its fan starts after a three minute delay so the air around the unit heats first, and that on battery backup during a power outage the remote will not run the fan at all. Those are ruled out first, then the parts the fan depends on are tested in turn.

The fan repair stays its own estimate line, apart from any ignition work. That way you can see what each fault costs and approve them separately.

• Power at the receptacle that feeds the fan
• The thermostatic sensor that switches it on
• The speed control or remote fan setting
• The motor and its wiring

Gas company or 911 first, then our emergency line

If you smell gas or a carbon monoxide alarm sounds, get everyone out of the house first, then call 911 or the gas company from outside. Do not light anything or touch electrical switches on the way out. That comes before any call to a repair company, including ours.

Once the gas company or fire department has made the home safe, our 24/7 emergency line is there for the fireplace itself. That covers a unit the responders shut off and told you to keep off until it is checked, a fireplace damaged in an incident, or controls that no longer respond.

Our technician starts with the rating plate and with what happened, what the responders did and what was shut off. The fireplace stays off until the cause is found and written on your estimate. For homes in Roosevelt Park, the free inspection and written estimate apply to emergency calls too.