Family-owned chase cover service in Southern Oaks
Chase cover replacement in Southern Oaks that starts with a free inspection and ends with a water test on the finished top.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Your Southern Oaks chase top, item by item
- Open gap at the pipe kept as the manual directs
- Seams sealed where the manual calls for it
- Water test on the finished top where footing allows
- Workmanship warranty on the installation
What goes into a new chase top in Southern Oaks
Measuring over the finished siding
The size that matters is the outside of the chase at the top, taken over the siding, stucco or trim. Framing dimensions are smaller by the thickness of every layer added later. A cover built to framing size sits inside the finish rather than lapping over it, and water runs into the joint. We measure each side at the top of your Southern Oaks chase, note where trim boards stand proud and size the skirt to clear the thickest point with room to fasten.
Which joints get sealant and which stay open
Sealant has a place on a chase cover, and a limit. Seams in the sheet and the joint where the collar meets the top are sealed, since the manuals call for caulking seams to prevent leaks. The gap between pipe and collar stays open, and ventilation openings in the termination are never sealed. We follow the written instructions for your fireplace system joint by joint, because a bead run around everything can trap water or block openings the system needs.
Fitting a cover to a stucco chase
On a stucco chase, the skirt laps over a hard, textured finish that does not flex the way siding does. The top edge of the stucco needs to be sound, since cracks there let water in behind the skirt. We check the stucco at the top before measuring and size the skirt to clear its thickness. Any cracking we find is noted, and stucco repair is described separately from the cover so you can decide on each. Where the stucco has a foam trim band at the top, we check that it is sound before the skirt goes over it.
Coordinating with a roofer
The chase cover and the roof meet only at the base of the chase, where flashing ties the enclosure into the roof. During a reroof, that base flashing is usually redone by the roofer, while the cover at the top is a separate component. Scheduling the cover just before or right after the roof work avoids extra foot traffic on new shingles. We coordinate timing with your roofer and keep each contractor's scope in writing. If the roofer is already scheduled, tell us the dates so the cover can be measured before the old roof comes off.
Other work in Southern Oaks
-
-
-
-
-
-
Learn more about chimney chase cover replacementSouthern Oaks services
Related chase cover work
Asked in Southern Oaks about chase cover replacement
What is the difference between a chase cover and a chimney cap?
The chase cover is the broad metal lid over the framed enclosure. The cap is the smaller hooded part on the chimney pipe. Either can rust, and we identify which one needs work before quoting.
Do I need to be home for the work in Southern Oaks?
For the inspection, someone should let us look at the fireplace inside. Installation happens on the roof, so it can often be done while you are out, as long as access is arranged.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.