Rebuild your chimney above the roofline in Southport
Rebuild specialists serving Southport. The boundary, the height and the liner are settled before demolition starts.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Rebuild decisions made in writing for Southport
A rebuild is only as good as its plan. Here are four of the items we pin down in Southport.
- Removal boundary down to sound masonry
- Crown or cap with drip edge and bond break
- Flue liner kept, replaced or relined
- Cap and screen refitted or replaced
Planning the rebuild at your Southport home
Questions like these come up on nearly every rebuild we quote in Southport.
Relaying the section above the roof
The part of a chimney above the roof is exposed on every side, so it tends to fail first. Relaying it usually means taking the crown, the top courses and any loose units down to firm brick, then building back up in full mortar joints.
For homes in Southport, this top-section rebuild is often the job that restores a chimney without touching the rest. It also gives our crew a chance to reset the flashing, check the liner and measure the finished height before the new crown goes on.
Masonry chimneys must be lined
The Florida Residential Code, section R1003.11, requires masonry chimneys to be lined, with lining material appropriate for the appliance connected. The liner keeps heat and flue gases inside a channel built for them.
A rebuild exposes the liner at the top and often further down. Our crew checks whether the existing liner in your Southport chimney is present, continuous and in serviceable condition, and the estimate says whether it stays, is extended through the new work or needs its own relining job.
Air space between the chimney and framing
The code requires an air space between a masonry chimney and combustible framing. It asks for 2 inches or more for a chimney that is indoors or built into an exterior wall, and 1 inch or more for one that stands wholly outside.
On rebuilds that pass through the roof or attic of your Southport home, our crew keeps that gap clear and checks that framing, decking or insulation has not been pushed against the masonry. Anything found touching the chimney is noted and corrected in the plan.
Counterflashing set into the new joints
Where a chimney meets the roof, the flashing is in two parts. Base or step flashing works with the roof covering, and counterflashing laps over it from the chimney side, usually let into a mortar joint.
A rebuild through the roof line is the right time to cut new reglets or build the counterflashing into the courses as they go up. Our crew plans the flashing for your Southport chimney before the masonry reaches the roof, so the two parts meet properly.
Other work in Southport
-
-
-
-
-
-
Before your chimney rebuild in Southport
Anything missing here is one phone call to our Southport team.
How do you decide where the rebuild stops?
We check the bond of the units, the depth of sound mortar and the condition of the brick course by course. The rebuild stops where the masonry can carry new work, and that point is written into the estimate.
Will the work damage my roof?
The roof around the chimney is covered before dismantling, material goes down by bucket or chute, and any roofing lifted to reset flashing is restored. The roofing scope is part of your Southport estimate.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.