Local chimney flashing repair in Spring Isle
Water at the chimney base rarely stops by itself. Call our Spring Isle team for a free inspection and a flashing repair that holds.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Checked before any roofing comes up in Spring Isle
Your written scope in Spring Isle starts with these checks and shows 10% off if you book within 72 hours after the inspection.
- Back pan or cricket on the uphill side
- Crown, cap and brick checked as other water paths
- Valleys and downspouts draining toward the chimney
- Findings that need a separate decision
Flashing repair explained for Spring Isle homeowners
Our team in Spring Isle walks every homeowner through points like these.
Chimney flashing during a new roof
A roof replacement is the natural time to renew chimney flashing, because the roofing around the chimney is coming off anyway. Reusing tired step flashing under a new roof puts old metal at the new roof's weakest point.
Tell us your roofing schedule early. We can inspect the chimney before tear-off, replace the counter flashing and repair the masonry it anchors into, then let the roofer set the base and step pieces to the new covering, or handle them ourselves where agreed. The sequence is written down so nobody assumes the other trade has it covered.
Water that gets behind the counter flashing from above
Brick and mortar absorb water. When the masonry above the roofline is saturated, water can move down inside the chimney wall and come out behind the counter flashing, where no amount of work on the outside metal will stop it.
Clues include dampness on the chimney inside the attic, above the roof deck, and wet spots that continue after new flashing is in. We look for those signs and, when they show up, recommend the masonry or crown repair that deals with water entering higher up.
Reflashing one side versus the whole chimney
Sometimes only one face of the chimney has failed. Replacing that face alone is possible when the pieces around it are sound and the new work can lap correctly into the old.
When the remaining flashing is near the end of its useful life, a full reflash may be the better value, since the roof is opened only once. We explain the tradeoff and put both options in writing so you can choose. A one-side repair also has to tie into the corner pieces of the faces beside it, and we check those folds before promising that the old and new metal will work together.
Flashing against a stone chimney
Natural and cultured stone have uneven faces and irregular joints, which makes setting counter flashing harder than on brick. Water can also run behind stone along joints that are not level.
We look for a joint or a line where counter flashing can be anchored and sealed properly. Sometimes a groove is cut to create a clean line across the stone. We explain the approach for your chimney before any cutting. Mortar joints between stones can also let water in above the flashing, so we look at the stonework just above the roofline before blaming the metal below it.
Other work in Spring Isle
-
-
-
-
-
-
Learn more about chimney flashing repairSpring Isle services
Flashing repair answers for Spring Isle homeowners
Our family-owned team in Spring Isle answers the questions that come up most on flashing jobs.
Does my chimney need a cricket?
The Florida Building Code, Residential, calls for a cricket on the ridge side of a chimney more than 30 inches wide. We measure your chimney and tell you whether the rule applies. Cricket work is quoted on its own line.
What should I look for after a big storm?
From the yard, look for metal standing away from the masonry, bent edges or pieces that are gone. A leak that starts right after a storm usually traces to a piece that was already weak. If you see anything, book a free inspection before the next heavy rain and keep the ladder in the garage.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.