Chimney step and counter flashing repair in Spring Lake
Tell us where the stain shows. Our pros in Spring Lake climb up, find the failing layer and put the fix in writing.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Line by line, your flashing proposal in Spring Lake
Four of the points our specialists record on a flashing job in Spring Lake, with upfront pricing on each line.
- Each chimney face where it meets the roof
- Counter flashing and the joints that hold it
- Laps between counter and base flashing
- 10% off within 72 hours after the inspection, shown in writing
Chimney flashing details that matter in Spring Lake
Here is how our local team thinks through a flashing repair at your Spring Lake home.
How far counter flashing should lap the base
The overlap between counter flashing and the base flashing beneath it is what keeps blowing rain from getting behind the seam. BIA Technical Note 19B calls for the counter flashing to lap the base flashing by at least 3 inches.
Short laps are common on older repairs where a new piece was cut to suit an old joint. From the yard they look fine. On the roof we measure the overlap on each face and note any stretch that falls short, because a lap that is too shallow can let water in even when every piece looks intact.
The corners where many leaks begin
Every chimney corner is a place where two flashing faces meet and the metal has to fold. BIA Technical Note 19B describes base flashing installed first on the faces perpendicular to the ridge, with tabs at each corner that wrap onto the neighboring faces.
Corners without those tabs, or with a tab torn at the fold, leave a small open seam right where water gathers. We check all four corners closely, since a pinhole there can explain a stain that appears only during a long rain. Corner work is listed on its own in the estimate so you can see what it involves.
Painting flashing to match the chimney
Some homeowners want the flashing painted to match the brick, the stucco or the roof. Paint can protect certain steels and make the junction less noticeable from the street, but it must suit the metal and go on a clean, prepared surface.
We tell you which flashing metals take paint well and which are better left bare. If you choose paint, the product and color are recorded in your scope so the finish can be matched later.
When a small flashing repair is enough
Not every leak calls for a full reflash. A single loose counter flashing piece, a failed joint where the metal enters the masonry or a torn corner tab can sometimes be repaired on its own, provided the rest of the flashing is sound.
We tell you honestly when a small repair will do the job. It is written up with what it fixes and what it does not, so you decide with the whole picture and without pressure to buy more than the chimney needs.
Other work in Spring Lake
-
-
-
-
-
-
Learn more about chimney flashing repairSpring Lake services
Flashing repair answers for Spring Lake homeowners
Questions we hear on flashing visits in Spring Lake, answered plainly.
Can you fix chimney flashing without replacing my roof?
Usually, yes. We lift only the roofing around the chimney, replace the flashing and restore the shingles or tile we moved. A full roof replacement comes into it only when the roof itself is worn out.
How do you decide between a repair and a full reflash?
Flashing usually wears out gradually, with spreading rust, cracked sealant, lifted counter flashing edges and opening corners. One sign alone may not leak yet. When several show on one chimney, we explain whether a repair buys real time or a full reflash makes more sense, and both options go in writing.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.