Skip to content

Proudly American | Family owned

Same-day service available

(352) 675-6376 Book Online

Electric fireplace installation from local pros in Stone Crest

Family-owned electric fireplace installation for Stone Crest homes, with mounting, power and finishes written into your estimate.

  • Licensed & insured
  • Locally run
  • Family owned and operated
  • Same-day service available
4.8 out of 5 from 736 reviews
  • Google
  • Yelp
  • Facebook

Installation details we put in writing in Stone Crest

These items keep an electric fireplace job in Stone Crest from turning into a second trip.

  1. Framed opening size and sill depth for a recessed unit
  2. Electrical work by an electrician, listed on its own line
  3. Controls, remote and wall switch setup
  4. Workmanship warranty on the installation we perform

Before an electric fireplace goes on your wall in Stone Crest

A closer look at the work, from our family-owned crew serving Stone Crest.

When the wall is too shallow

A standard interior wall cavity is only a few inches deep, and many recessed fireplaces are deeper than that. The unit either needs a thicker wall, a built-out section or a partial recess where part of the body sits proud of the surface.

We measure the unit's depth against your wall and show you the options. A built-out wall can also hold a TV and shelving, which is why many homeowners choose a media wall. The estimate describes the framing needed to give the fireplace the depth it requires.

A mantel above an electric fireplace

A mantel shelf above an electric fireplace looks natural, but it sits right where warm air rises from a top-discharge heater. Some manuals say how far above the unit a mantel or shelf may go.

We check your model's guidance before choosing the mantel height. If the heater discharges downward instead, the concern shifts to what sits below. Either way, the mantel position is written into the plan so it suits both the look you want and the unit's instructions.

Planning during construction or a remodel

The best time to plan a built-in electric fireplace is before the drywall goes up. The opening, the sill, the power and the TV blocking can all be set up while the studs are open.

Send us the fireplace model and the wall plan early. We work from the manual to give your builder or remodeler the opening size, the connection point and the clearances. When the wall is finished, the fireplace slides in and the trim goes on without surprises.

A tight finish at the trim

The trim around a built-in electric fireplace frames the whole unit, and gaps or uneven reveals show at a glance. The finish material has to meet the trim cleanly without covering vents or the heater outlet.

We set the unit level, then fit the finish to it, checking the reveal all the way around. Where drywall meets the trim, the edge is straight and painted. Where tile or stone meets it, the cuts are clean. It is the detail people notice most.

Before your electric fireplace install in Stone Crest

If your question is not here, our Stone Crest team is a phone call away.

Can an electric fireplace go under my TV?

Often, yes, if the fireplace manual and the TV maker's guidance agree on the layout. The heater outlet direction and the distance between the two matter most. We plan both on the wall before anything is mounted.

Can you put an electric insert in my old fireplace?

Yes, in most sound, dry fireboxes. We measure the opening, remove old doors or grates, close drafts behind the insert as its manual directs and bring power to it. A trim kit then finishes the face.

Request your free estimate

Share the job details and arrange a free inspection with our local team.

  • Free inspection
  • No hidden fees
  • Family owned and operated

Need an answer now? Call (352) 675-6376

Tell us what needs attention. We will contact you to arrange your free inspection.

Call(352) 675-6376