Chimney sweep and fireplace cleaning in Summerport Beach
Every sweep in Summerport Beach ends with a visual check and a written record you keep.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
From cap screen to hearth, in writing
- Room covered and fireplace opening sealed
- Stove connector pipe cleaned and joints reset
- Ash dump opened and ash pit checked
- Glass doors and frame cleaned after brushing
Chimney sweep work from the roof down
Rust flakes and water marks inside the flue
Rust in the sweep debris, orange streaks down the firebox walls, or a damper rusted at the edges all point the same way. Water is getting into the chimney somewhere above.
The sweep removes the rust flakes along with the soot, but it does nothing about the water. On a masonry chimney the path can be a missing cap, a cracked crown or open joints. On a factory-built chimney it can be the cap, the storm collar that seals the pipe, or the chase top.
Our crew traces the water as far as the cleaning allows and notes each suspect point on your estimate, with leak repair priced apart from the sweep. Until the source is fixed, water keeps rusting the damper and staining the firebox. On a factory-built system, any failed cap or collar is replaced with the maker's listed part.
What our 24/7 emergency line is for
Fire, smoke and carbon monoxide come first. If a fire is burning in the chimney, smoke is filling the room or a CO alarm is sounding, get everyone out of the house and call 911 before calling anyone else.
After that, the 24/7 emergency line is there for chimney problems that cannot wait for a regular appointment. An animal has dropped into the firebox, a cap is hanging off the chimney, the damper is stuck open with debris falling through it, or the fire department has told you not to use the fireplace until it is checked.
Our crew in Summerport Beach secures the problem first, whether that means removing debris, closing off the flue or covering an open top, and then gives you a written estimate for the permanent fix. The free inspection still comes before any repair.
Sweeping a metal chimney inside a framed chase
Many factory-built fireplaces vent through a metal chimney enclosed in a framed chase, often built against an outside wall, with only the cap showing above a metal chase top.
One maker's instructions, DuraVent's for its DuraChimney II, show how that top goes together. The chase top flashing leaves a ventilation opening around the pipe and sits on spacers above the chase framing, a storm collar is sealed to the pipe above it, and the chimney cap sits above both. Parts come from the listed system, not from another maker.
When our crew sweeps a chase chimney in Summerport Beach, they clean the flue from the top, look at the chase top and storm collar while they are up there and note any gap that could let water into the chase. Chase repairs are quoted apart from the cleaning.
An ash dump that has not been emptied
Some masonry fireplaces have a small metal door in the firebox floor that drops ash into a chamber below, with its own cleanout door lower down or outside. Ash dropped there is out of sight, and it can build up for years.
A full ash pit can back up into the firebox, hold moisture and give off a stale smell. The door in the firebox floor can also rust shut or warp so it no longer closes.
During a sweep our crew opens the ash dump, checks how full the pit is and empties it through the lower cleanout when it can be reached. A warped or rusted door is noted for repair on the estimate, and ash from the pit goes out in a metal container like any other ash.
Other work in Summerport Beach
-
-
-
-
-
Learn more about chimney sweep and chimney cleaningSummerport Beach services
Related chimney sweep work
Chimney sweep questions in Summerport Beach
Will the sweep leave soot in my living room?
It should not. Our crew covers the path to the hearth, seals the fireplace opening while the flue is brushed and bags the debris at the source. If soot turns up where it should not be, tell us, and our 100% satisfaction guarantee applies.
Can you clean a factory-built fireplace and its metal chimney?
Yes. We follow the maker's care instructions, use brushes that will not scratch the metal flue and reset the cap the way the system was designed. Any damaged part is quoted with a matching replacement listed for that system.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.