Rebuild your chimney above the roofline in Timber Springs
Rebuild specialists serving Timber Springs. The boundary, the height and the liner are settled before demolition starts.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Rebuild decisions made in writing for Timber Springs
These checks keep a rebuild in Timber Springs from turning into a second rebuild later.
- Flashing and counterflashing at the roof
- Access by roof, ladder or staging
- Fireplace opening sealed against dust
- Original brick sorted for reuse
Rebuild details that matter for Timber Springs homes
Questions like these come up on nearly every rebuild we quote in Timber Springs.
Keeping dust and debris out of the house
Work at the top of a chimney can send grit and mortar down the flue. Without precautions, it ends up in the firebox and sometimes in the room.
Our crew seals the fireplace opening and, where practical, blocks the flue below the work area before dismantling starts on your Timber Springs chimney. The seal stays until the top is rebuilt and the flue is checked for fallen material. Your living room should look the way you left it. If the chimney serves more than one opening, each one is covered.
A liner suited to what the chimney serves
The code ties the liner to the appliance. The lining must suit the type of appliance connected, following that appliance's listing and the maker's instructions. A liner that served one use may not suit another.
Tell us what the chimney at your Timber Springs home serves today and whether that might change. Our pros take it into account when deciding how the rebuilt section meets the liner, so the new masonry and the flue inside it are planned as one assembly. A change of plan later may affect the liner, so it helps to mention it now.
A new crown with a drip edge and bond break
Section R1003.9.1 of the Florida Residential Code finishes a masonry chimney in concrete, metal or stone with a drip at the edge, plus a caulked bond break at each flue liner done to ASTM C1283.
Every rebuild our crew finishes in Timber Springs ends with a top that meets that description. The estimate names the material, and the new crown is built to shed water away from the brick instead of letting it run down the face of the fresh work. A top that only looks finished falls short unless it carries these details.
Tooled joints that shed water
The shape of a finished joint affects how water behaves on the face of the chimney. Brick industry guidance notes that concave, V and grapevine joints tooled into the mortar are the profiles that resist water penetration most effectively in exterior brickwork.
On your Timber Springs rebuild, the joint profile is chosen with the existing masonry in mind. When the old joints were concave, the new ones match. If an unusual profile was used, we discuss the options before the new courses go up. A profile that sheds water is one of the quiet details that keeps new work dry.
Other work in Timber Springs
-
-
-
-
-
Before your chimney rebuild in Timber Springs
Our family-owned team in Timber Springs answers what homeowners ask us about rebuilding.
Can my chimney be repaired instead of rebuilt?
Often it can. Spalled units, worn joints and a cracked crown can each be repaired while sound masonry stays. If a smaller repair will hold on your Timber Springs chimney, we quote that instead.
Do I need to be home during the rebuild?
Not for most of the work, which happens on the roof. We do ask to walk the finished chimney with you at the end, and someone needs to be available if a decision about hidden damage comes up.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.