Family-owned stone chimney repair serving Timberleaf
We reset stones, repoint joints and match the mortar on chimneys in Timberleaf. Book within 72 hours after your free inspection and take 10% off.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Line by line on your stone chimney in Timberleaf
Every line comes from what we find on your stonework in Timberleaf, never from a stock list.
- Replacement stone sourced and compared
- Drainage at the base and terminations checked
- Gutters and runoff onto the stone noted
- Joints tooled to match the existing profile
How we repair stone chimneys in Timberleaf
Resetting, repointing and the rules behind them, as our crew in Timberleaf applies them.
Finding hollow stones by tapping
A stone with voids behind it sounds different when tapped. On a veneer chimney, we tap every stone within reach and mark the ones that sound hollow or move.
One hollow stone in a sound wall may just be reset. A cluster of hollow stones points to a wider bond problem in the setting bed or scratch coat, and the plan changes accordingly. The findings show where the hollow areas are, so you can see why a repair covers the area it does.
Flashing where the stone starts and stops
The maker's instructions call for corrosion-resistant flashing or weep screed and a means of drainage at all penetrations and terminations of the stone cladding, with flashing type and locations following the applicable building code.
On a chimney, those edges include the roof line, the top under the cap and any trim transitions. Missing or failed flashing at an edge can explain water behind stone, so we check every edge on the chimney.
Acid cleaners and stone
Preservation guidance keeps chemical cleaners, acids above all, off dry masonry, and has the wall wetted thoroughly before any chemical and rinsed well after it. One manufactured stone maker rules out acid and acid-based products entirely.
Acid can etch some natural stones and discolor cast stone. We start with water and mild detergent, test anything stronger on a hidden spot and tell you in writing what was used and why.
Looking at the chimney from the attic
Where a chimney passes through an attic that can be entered safely, the inside of the chase or the chimney face there can show stains, damp framing or light where there should be none.
We look there when access allows, since it often explains what the outside only hints at. Nothing is disturbed, and anything we find is written into the findings with the part of the chimney it points to.
When veneer needs to come off and go back on
Sometimes veneer has failed across a whole chase, with corroded lath, missing barrier layers or trapped water throughout. Resetting stones one by one would leave the real problem in place.
Then the right repair is to remove the veneer, rebuild the barrier, lath and scratch coat to the maker's directions and reinstall the stone, reusing sound pieces. It is a bigger job, and we show you the evidence for it before recommending it.
Other work in Timberleaf
-
-
-
-
-
Stone chimney questions from Timberleaf
Weighing it up? Read these, then book the free stone check in Timberleaf.
How do I know if my chimney is natural stone or veneer?
Thin stones with a flat back over a mortar bed, a metal screed at the base or a framed chase usually mean manufactured or thin veneer. Solid stone chimneys have thick units that pass through the wall. We identify yours at the free inspection.
How often should a stone chimney be inspected?
Under NFPA 211, a chimney, its fireplace and its vents are inspected every year at a minimum. For a stone chimney, that yearly visit is a good time to tap the stones, check the joints and look at the cap and flashing.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.