Skip to content

Proudly American | Family owned

Same-day service available

(352) 675-6376 Book Online

Chimney waterproofing and sealing in Washington Shores

Repairs first, then a breathable water repellent on sound masonry. Our local family-owned team in Washington Shores starts with a free inspection.

  • Licensed & insured
  • Locally run
  • Family owned and operated
  • Same-day service available
4.8 out of 5 from 736 reviews
  • Google
  • Yelp
  • Facebook

The written waterproofing scope for your Washington Shores home

A short list with a big effect on the result. We confirm each item at your Washington Shores address before ordering product.

  1. Condition of the brick faces above the roofline
  2. Open, cracked or eroded mortar joints to repair first
  3. Surface cleaning needed before application
  4. Workmanship warranty on the application we perform

Waterproofing know-how from our Washington Shores crew

The points below shape the treatment we recommend in Washington Shores, and each one shows up in your written estimate.

How deep a penetrating repellent goes

Penetrating repellents work below the surface instead of on it. Masonry guidance puts their depth at up to about three-eighths of an inch, and individual products vary with the porosity and moisture of the masonry at the time of application.

That depth is why a penetrant tends to hold up under sunlight better than a surface film, and why it leaves the look of the chimney largely unchanged. It is also why surface prep matters. Dirt, salt and old coatings in the pores block the product from getting to where it needs to be, so we clean first.

The second pass while the first is still wet

For maximum penetration, SaverSystems recommends a wet-on-wet application of its water-base chimney product, retreating the surface within three to five minutes after the first pass. A second coat on dry masonry does not behave the same way.

We work in sections small enough to keep that timing, especially on sunny faces where the surface dries quickly. On porous brick, the second pass fills pores the first one could not reach. On dense brick, we watch closely so the surface is saturated without puddling product on the ledges.

Chimney moisture on a home inspection report

Home inspectors often flag chimney masonry that looks porous, stained or damp. The note rarely says what should be done about it, and a buyer and seller can read it very differently.

Our team inspects the chimney and separates the findings into repairs, a possible treatment and items that are fine as they are. The written estimate spells each one out with a price, which gives both sides something concrete to work from. We keep the language plain and the claims modest.

A musty smell and wet masonry

A damp, musty smell from the fireplace after a rainy spell can come from masonry holding water. It can also come from an uncapped flue, water on the smoke shelf or old deposits reacting with humidity.

We sort out the source during the inspection. If the brick is absorbing water and the joints are sound, a breathable repellent can help it dry and stay drier. If the smell has another cause, we tell you which repair addresses it. The fireplace smells guide covers the other causes in more depth.

What people in Washington Shores ask about chimney sealing

Answers from our specialists in Washington Shores, with no sales pressure.

Does the 72-hour 10% discount apply to waterproofing?

Yes. Any service booked within 72 hours after your free inspection is 10% off, and chimney waterproofing qualifies, including any repairs on the same estimate. Mention it when you book and we will show the savings in writing.

Do I need to be home during the treatment?

Not always. We need access to the roof and to the area around the base of the chimney. If you can be home at the start and for the walkthrough at the end, that is a good time to ask questions and see the result.

Request your free estimate

Share the job details and arrange a free inspection with our local team.

  • Free inspection
  • No hidden fees
  • Family owned and operated

Need an answer now? Call (352) 675-6376

Tell us what needs attention. We will contact you to arrange your free inspection.

Call(352) 675-6376