Chimney stucco repair for Washington Shores homeowners
Local specialists repair chimney stucco in Washington Shores in proper coats, matched to your texture. No hidden fees.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
What we measure on Washington Shores chimneys before quoting stucco
These are the points that decide how big a stucco repair is. You see each one in writing in Washington Shores.
- Hollow or loose areas found by sounding each face
- Barrier behind the lath on a framed chase, if opened
- Flashing at the roof line, priced separately
- Written record of materials and areas repaired
The way we handle stucco chimneys in Washington Shores
Details our Washington Shores team explains on every stucco chimney visit.
Chalky old paint on chimney stucco
An old coating that leaves powder on your hand is a poor base for new paint. The Park Service guidance notes that latex paint will not stick to chalky or powdery areas.
Before any finish goes on, we check how well the existing coating holds and prepare the surface to suit the new one. Skipping that step is a frequent reason a freshly painted chimney starts peeling again. A quick rub test on each face shows how much preparation the old coating needs.
Why we avoid adding lath over sound masonry
Fastening metal lath to sound brick or stone damages the masonry, and the Park Service guidance warns that even slight moisture can rust that lath, which expands and can spall the stucco and the masonry behind it.
On a sound masonry chimney we bond the new stucco directly to the prepared surface. Lath goes where the assembly calls for it, such as a framed chase, and is never a shortcut on masonry. Where old lath is already fixed to masonry and rusting, we remove it in the repair area rather than patch over it.
Dampening the base before the first coat
A dry masonry base can pull water out of fresh stucco too fast, which weakens the bond. The Park Service guidance calls for thoroughly wetting masonry or wood lath before patching, though not metal lath.
Our crew prepares the base to suit what is under your chimney's finish. It is a small step on the day, and it is one of the details that separates a patch that holds from one that cracks. On lath, the approach changes, and the product instructions decide what the base needs.
Why we never blast stucco with high pressure
High-pressure washing can erode stucco texture, force water into cracks and loosen weak areas. The Park Service guidance describes low-pressure water washing with soft brushes for cleaning stucco.
We clean chimney stucco gently before repairs and coatings, and we suggest you do the same. If a washer has already damaged the texture, we include that area in the repair scope. A soft brush, clean water and patience remove surface dirt without roughening the texture.
Other work in Washington Shores
-
-
-
-
-
Learn more about stucco chimney repairWashington Shores services
Stucco chimney questions from Washington Shores
Short answers from our stucco team in Washington Shores. Call for anything not covered here.
What if the wood behind the stucco is soft?
Then the job includes more than a finish repair. We stop, show you what we found and explain the framing repair, which is priced separately as chase repair. Nothing is added without your approval.
Can you repair stucco on a chase with a metal flue inside?
Yes. On a framed chase around a factory-built chimney, we repair the stucco skin without disturbing the listed pipe and supports inside. Any concern with those parts is written up separately.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.