Fireplace inserts fitted by local pros in Wedgefield
From an open fireplace to a closed wood heater in Wedgefield, planned around your firebox and your room.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
The fit, the flue and the hearth, checked in Wedgefield
An insert fits or it does not. These are the checks that decide it, written down before anything is ordered.
- Old insert, doors, grate and screen removed
- Clearances to mantel, side trim and top facing measured
- Our workmanship warranty on the insert work we do
- Existing chimney cap checked for fit with the liner
Wood insert installation, explained by our Wedgefield team
Three parts of the job our insert specialists walk through with Wedgefield homeowners.
What a wood-burning insert changes about an open fireplace
A wood-burning insert is a closed steel or cast iron firebox with a glass door that slides into the opening of an existing fireplace. The fire burns behind that door on an air supply the owner controls, and the smoke leaves through a liner connected to the collar on top of the unit.
An open fireplace pulls a steady stream of room air up the chimney, with a lively fire or a dying one. A sealed firebox burns on a measured supply, so more of the heat stays in the room. Our installers walk through that difference at the free inspection, before any model is chosen.
A wood mantel close to the opening
A mantel that was acceptable above an open fireplace can sit inside the clearance of an insert, because the hot body and door of the unit sit right at the opening. In the Pacific guide, the mantel minimum is 24 inches, measured from the insert body.
When a mantel is too close, the choices are a model whose manual lists a smaller figure, a mantel raised or replaced with noncombustible material, or a protection method the manual itself describes. We lay out those options with their costs in writing and let you choose.
The smoke shelf and the damper frame
Above the firebox of a masonry fireplace, the throat narrows at the damper, and behind it sits the smoke shelf with the smoke chamber rising above. A liner has to pass through this constricted area on its way to the collar.
Where the damper frame is too tight for the liner, the manual's exception may allow removing the damper plate or part of the frame, provided the structure stays sound and combustibles stay protected. We explain in advance exactly what, if anything, we plan to remove.
Warming a cold liner on start-up
A cold flue resists draft until the gases warm it. Starting with paper and small, dry kindling heats the liner quickly and gets exhaust moving upward before larger splits go in.
We show you the start-up that suits your model, with the air fully open until the fire is established. It keeps smoke from rolling out when the door is opened early in the fire, and it gets the insert to a clean burn sooner, which is also when the glass stays clearest.
Other work in Wedgefield
-
-
-
-
-
-
Learn more about wood-burning fireplace insert installationWedgefield services
Fireplace insert questions, answered for Wedgefield
Undecided? These help, and the insert visit in Wedgefield costs nothing.
Will my hearth be big enough?
Insert manuals set how far the noncombustible hearth must reach in front of and beside the opening, and whether a flush hearth needs to reach further. We measure yours and write any extension into the estimate.
Does the insert blower need a special outlet?
It needs a properly grounded outlet within reach of its cord, wired to code. If there is no suitable outlet, an electrician adds one as separate work with its own line on the estimate.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.