Chimney cap replacement for homes in Wedgewood Groves
A cap sized to your flue, fastened to hold, and a free inspection first. Our local family-owned team serves Wedgewood Groves with upfront pricing.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Line by line, your cap proposal in Wedgewood Groves
Your written scope in Wedgewood Groves starts with these checks and shows 10% off if you book within 72 hours after the inspection.
- Spark screen opening size and open area
- Roof access and protection of the roof surface
- Listed termination parts on a factory-built chimney
- 10% off shown for work booked within 72 hours
Chimney cap details that matter in Wedgewood Groves
Straight answers about cap work in Wedgewood Groves, from the people who do it.
The mesh opening range for a chimney spark screen
The same code section sets the size of the screen openings. They may not let a sphere larger than one half inch pass through, and they may not block a sphere smaller than three eighths of an inch.
That range stops larger embers while keeping the mesh open enough to breathe. A screen finer than the range clogs faster and restricts the outlet, and a coarser one lets larger embers and some animals through. We check the mesh on the cap we propose against those limits and note it in writing, so you know the screen is suited to a wood-burning fireplace.
One screen that keeps out animals and stops embers
The screen around a cap serves two purposes at once. It blocks birds, squirrels and larger insects from the flue, and on a wood-burning fireplace it stops larger embers from leaving the chimney top.
The Florida code's opening range for spark arrestors balances those jobs against the need for the flue to breathe. We choose mesh inside that range rather than a finer screen that would clog, and we check the joins where the screen meets the lid and the base, since gaps there defeat both purposes.
Flues that sit off center on the crown
Not every flue sits in the middle of its chimney. Offset flues, flues close to one edge of the crown or flues set at an angle can make stock caps hard to fit.
We measure the position of each flue relative to the crown edges and to each other. A single-flue cap may still fit on the tile, while a crown-mounted cap may need a custom footprint. We recommend the simplest option that fits well and explain why a stock cap will or will not work.
How a typical cap replacement visit runs
We arrive, confirm the job with you and set up our ladder and roof access. The old cap comes off, the tile or crown underneath is checked and the new cap is measured against the flue before it is fastened.
Once the cap is secure, we check the screen, the lid clearance and the fasteners, then clean up the work area and the ground below. Before leaving, we walk you through what was done and answer any questions. The paperwork shows the cap installed and the warranty on our work.
Other work in Wedgewood Groves
-
-
-
-
-
Learn more about chimney cap installation and replacementWedgewood Groves services
Cap replacement answers for Wedgewood Groves homeowners
Our family-owned team in Wedgewood Groves answers the questions that come up most on cap jobs.
Is stainless steel or copper the right cap for my home?
Both suit an inland chimney. Stainless is chosen for durability and value, copper mostly for its look as it weathers. We price both in the estimate so you can compare them side by side.
Do I need to be home while you replace the cap in Wedgewood Groves?
Not always. We need access to the roof and to the fireplace below if the damper should be checked. If you can be home for the walkthrough at the end, that is a good time for questions.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.