Chimney flashing repair for Windermere homes
Family-owned chimney flashing repair for Windermere homes, with a written estimate before any roofing comes up.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Your free flashing inspection in Windermere looks at
Checked and noted by our local family team in Windermere, then explained in plain language.
- Corner folds and tabs on all four corners
- Exposed fasteners and old mounting holes
- Sealant products and where each one goes
- Findings that need a separate decision
Our approach to chimney flashing in Windermere
What our pros check and why, on flashing jobs across Windermere.
Flashing metal must resist corrosion
The Florida residential code, in Section R903.2.1, requires metal flashing to be corrosion resistant, with a thickness not less than Table R903.2.1 lists for the metal chosen, or to comply with RAS 111. Thin, uncoated steel that rusts through after a few seasons does not meet that requirement.
When we replace flashing, the metal type and thickness are written into your estimate. That lets you compare quotes on equal terms and gives the next person on your roof a record of what was installed. It also keeps a repair from failing early because the cheapest sheet in the shop was cut to fit.
Roof pitch, height and access
How the crew reaches the chimney affects the time, equipment and care the job needs. A steep pitch, a two-story eave or a chimney tucked between rooflines calls for more setup than a low, gentle roof.
We assess access during the free inspection and explain what equipment will be used and where ladders will stand. If plantings, screen enclosures, solar panels or skylights sit near the work, tell us so the plan protects them from the start.
Leaves and grit behind the chimney
The uphill side of a chimney catches leaves, pine needles and shingle grit that wash down the roof. Wet debris holds water against the back flashing and can clog a cricket valley. It also hides rust and open seams from anyone looking up from the yard.
We clear that debris during the inspection and look at the metal underneath. If debris builds up quickly on your roof, having it cleared now and then helps the back flashing last.
Flashing against a stone chimney
Natural and cultured stone have uneven faces and irregular joints, which makes setting counter flashing harder than on brick. Water can also run behind stone along joints that are not level.
We look for a joint or a line where counter flashing can be anchored and sealed properly. Sometimes a groove is cut to create a clean line across the stone. We explain the approach for your chimney before any cutting. Mortar joints between stones can also let water in above the flashing, so we look at the stonework just above the roofline before blaming the metal below it.
Other work in Windermere
-
-
-
-
-
What people in Windermere ask about chimney flashing
Short answers from our chimney team in Windermere. Call for anything not covered here.
Does my chimney need a cricket?
The Florida Building Code, Residential, calls for a cricket on the ridge side of a chimney more than 30 inches wide. We measure your chimney and tell you whether the rule applies. Cricket work is quoted on its own line.
What if you find rotten decking once the roof is opened?
We stop and show you before going further. Decking repair is listed as a separate item, and nothing is added to the job without your approval.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.