Chimney damper replacement in Zellwood
A free inspection tells you whether your damper needs a new handle, a freed plate or a full replacement.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
What the free damper inspection looks at
- Full open-to-closed travel test
- Rust depth on the plate and frame
- New throat damper supplied and set
- 10% off any service booked within 72 hours
The damper work behind a fireplace that works
What happens to the old damper under a top damper
When a top-sealing damper is added, the old throat damper below still sits in the fireplace. It may be left open, fixed open or removed, depending on its condition and how the new damper is controlled.
We explain what will happen to the old plate before any work starts, so nobody in the house later closes a forgotten handle that no longer matters or leaves a loose plate to rattle. The plan goes in writing.
If the old throat damper is removed, the opening is checked and any rough edges are dressed. If it stays in place, we make sure it cannot swing shut by accident. Either way, you will know what the fireplace has and how to use it.
Marking open and closed on the control
Many damper handles give no clue about which way is open. People guess, and a wrong guess means a smoky room or a damper left open all summer.
After any damper repair, our crew can add simple position marks near the control and walk you through them. It takes a minute and saves a lot of guessing.
Marks also help guests and family members who rarely use the fireplace. A clear mark makes it easy to check the damper before lighting a fire and again after it has gone out.
A damper that rattles in the wind
On windy days a loose damper plate can rattle or bang in the throat. It usually means the plate is off its seat, the pivots are worn or the control is no longer holding it firmly.
The noise is annoying, and it also means the damper is not sealing. Our technicians tighten, re-seat or replace the parts involved so the plate sits quietly and closes the way it should.
Rattling can also come from a loose cap or other parts higher in the chimney. If the damper is secure and the noise continues, we look higher up the chimney and explain what we find.
Testing the damper through its full travel
A damper repair is not finished until the plate opens all the way, closes evenly and stays where the control puts it. Our crew tests each position using the control itself, since that is how you will use it.
If the plate stops short or drifts, we adjust it before calling the job done. You see the result before we pack up, and the finished operation is written on the handover sheet.
Testing also includes checking that the plate does not rub or bind at any point. If it does, we adjust it before finishing, so you do not discover the problem on your first fire.
Other work in Zellwood
-
-
-
-
-
-
Learn more about chimney damper repair and replacementZellwood services
Damper repair questions we hear often
Can a stuck damper be repaired, or does it need replacing?
Many stuck dampers can be freed, cleaned and re-hung when the plate and frame are still sound. If the casting is warped, cracked or rusted through, replacement is the lasting fix. Our technician tells you which applies after the free inspection.
Should I keep using the fireplace if the damper will not open all the way?
No. Leave the fireplace unused until the damper is checked, since a partly closed damper can push smoke into the room. If a smoke or carbon monoxide alarm sounds, get everyone outside and call 911.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.