Your chimney damper replacement team in Apopka
Keep smoke out of the room and cooled air in the house. Free damper inspection, and 10% off work booked within 72 hours after it.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
What your damper estimate covers in Apopka
- Rust depth on the plate and frame
- Rain cap check to stop future rust
- Position marks on the damper control
- 10% off any service booked within 72 hours
Damper replacement done with care in Apopka
A damper you can work from the room
A damper only helps if you can open and close it without climbing into the fireplace. The code language for masonry fireplaces calls for the damper to be operable from the room containing the fireplace, which means a handle, lever or knob you can reach safely.
If your handle is missing, bent out of reach or disconnected from the plate, our technicians restore a working control. You should be able to set the damper position with one hand and know where it stands.
A control should also hold its position. If the handle drifts or the plate creeps shut, the damper is failing at its job even though you can reach it. Our technicians check that the control stays exactly where you set it.
Rotary damper controls on the fireplace face
A rotary control uses a small crank or knob on the face of the fireplace. Turning it drives a gear and rod that swing the damper plate open or closed. It is tidy and convenient until a gear strips or the rod works loose.
If the knob spins freely or turns with no effect, the drive between the knob and the plate has usually failed. Our technicians trace the rod, check the gear housing and tell you whether a part can be replaced or the damper needs to be.
Rotary drives are also sensitive to soot and rust in the gear housing. Cleaning the drive can sometimes restore it, while a stripped gear needs a new part. We check the whole path from knob to plate before recommending anything.
A damper that drops shut on its own
If the damper falls closed while a fire is burning, smoke comes straight into the room. That usually means the notch, stop or spring holding the plate open has worn out or broken.
Stop using the fireplace until it is repaired. Our crew replaces the worn holding parts when everything else in the damper checks out and replaces the damper when it is not. Before we leave, we open it fully and check that it stays put.
Some plates are weighted or shaped to stay open once set, and wear can upset that balance. Our technicians check how the plate hangs on its pivots and adjust or replace the parts that let it fall.
Damper damage after a chimney fire
If you think a chimney fire is burning right now, get everyone outside and call 911 before anything else. Afterward, know that a chimney fire can warp a damper plate, crack the frame and damage the flue above it. If you heard a loud roar in the chimney, saw sparks from the top or smelled strong smoke, the fireplace should not be used until it is inspected.
Our technicians check the damper along with the flue and smoke chamber after a suspected chimney fire. Anything beyond the damper goes on its own lines of the estimate so you see the whole picture.
After a chimney fire, the damper is only one part of the check. The flue, liner and smoke chamber also need a look before the fireplace is used again, and we explain what we found and what needs repair in writing.
Other work in Apopka
-
-
-
-
- Fireplace InstallationPlan the fireplace before opening the wall.
- Fireplace RestorationBring an unused fireplace back with a coordinated plan.
Learn more about chimney damper repair and replacementApopka services
Before you book damper work in Apopka
I can see daylight around the closed damper. Is that a problem?
It means the plate is not closing all the way, usually because it is warped, something sits on its seat or the control stops short. Cooled air slips out through that gap on hot days. We find which cause it is, fix it and look for light again before we leave.
What does the building code expect from a fireplace damper?
For a masonry fireplace, section R1001.7.1 of the Florida Building Code, Residential, wants a damper of ferrous metal, placed 8 inches or more above the top of the opening, in the fireplace or its chimney, with a control you can work from the room. Replacement dampers go in with those points in mind.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.