Fireplace inserts fitted by local pros in Apopka
We check the fireplace, the flue and the hearth in Apopka before you buy. Book within 72 hours after the inspection and take 10% off.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Before any insert is ordered for your Apopka home
The firebox, the flue and the hearth are measured in person in Apopka, and each result lands on your estimate.
- Firebox and damper area repairs listed separately
- Connector to the collar made as the manual shows
- Ember protection on the floor in front of the unit
- Insert leveled and door latch checked
A wood insert job in Apopka, start to finish
Each point below turns into a line on your written estimate in Apopka.
When a short direct connection is allowed
Some insert manuals also permit a positive or direct flue connection, in which a short stainless pipe runs from the collar through a sealed plate in the damper area into the first clay tile of the existing flue. Pacific notes that local codes may then call for a clean-out door, and a Travis manual lists a block-off plate as part of that method.
This route leaves the upper flue at its original, larger size and relies on sound tile above the joint. When your manual lists both methods, our pros explain each one, and we recommend the full liner unless the flue condition and the manual clearly favor the shorter path.
No chiseling into the fireplace to make a unit fit
Insert manuals warn against removing bricks or mortar from an existing fireplace. The exception in the Pacific guide is narrow: masonry or steel at the smoke shelf and the damper frame may come out to accommodate a liner, provided the structure is not weakened and protection for nearby combustibles is not reduced.
If a model only fits by cutting into the firebox walls, it is the wrong model for that fireplace. Our specialists would rather say so during the visit than weaken the masonry that separates your fire from the framing behind it.
Comparing two models for the same fireplace
Two inserts with similar heat output can differ in their minimum fireplace sizes, mantel and side clearances, hearth requirements, flue size and blower power. Those differences, more than the brochure photo, decide which one suits a given fireplace.
When you are torn between models, our specialists set them side by side against your measurements and explain the installation each would need. Sometimes the cheaper unit costs more to install, and sometimes the reverse, and you should know which before choosing.
The smoke shelf and the damper frame
Above the firebox of a masonry fireplace, the throat narrows at the damper, and behind it sits the smoke shelf with the smoke chamber rising above. A liner has to pass through this constricted area on its way to the collar.
Where the damper frame is too tight for the liner, the manual's exception may allow removing the damper plate or part of the frame, provided the structure stays sound and combustibles stay protected. We explain in advance exactly what, if anything, we plan to remove.
Other work in Apopka
-
-
-
-
-
-
Learn more about wood-burning fireplace insert installationApopka services
Wood insert questions we answer in Apopka
Short answers from our insert installers in Apopka. Anything else, just call.
Do I need a liner for a wood insert?
Most insert makers call for a stainless liner from the insert collar to the top of the chimney, and some also allow a short direct connection into the first flue tile. In a factory-built fireplace, one maker requires the full liner. We follow your model's manual.
Why is the insert glass turning dark?
One maker lists unseasoned wood and long burns at a low setting as common causes, because both work against the airwash that keeps the glass clear. Drier wood usually helps, and we can check the door seal if the glass keeps darkening.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.