Gas inserts installed in Apopka fireplaces
Our Apopka crew plans the vent, the gas line and the power together, so install day runs to plan.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Measured at your Apopka fireplace, priced in writing
What our Apopka crew confirms first, so the insert you pick is one that will fit, vent and connect.
- Masonry or factory-built fireplace, and what the insert manual allows
- Plates or insulation closing the gap around the liners at the damper
- Shutoff valve location and service slack in the gas line
- Barrier screen front ordered with the insert
The engineering behind a gas insert in Apopka
Worth reading before you approve a gas insert installation in Apopka.
Sealing where the gas line enters
The gas line reaches the insert through an opening in the unit or the old firebox. The Supreme manual allows the gap around the supply pipe to be sealed with caulk or aluminum foil tape rated for at least 300 degrees continuous exposure, or stuffed with non-combustible unfaced insulation, to prevent cold air infiltration.
It also says the gas line must not touch the outer wrap of the appliance. We route the line with that clearance and seal the entry point before the insert is pushed into its final position.
What counts as noncombustible
Insert manuals use the words combustible and noncombustible precisely. The Supreme manual defines noncombustible materials as those made entirely of steel, iron, brick, tile, concrete, slate, glass or plasters, or materials reported as passing ASTM E 136. Wood, compressed paper, plant fibers and plastics count as combustible, even when flame-proofed.
That matters when you choose a new face for the fireplace. Tile over a noncombustible backer may qualify where a painted wood panel would not. We check your finish choices against those definitions before anyone starts cutting.
Set level in every direction
Tipped forward or leaning to one side, an insert looks wrong and can strain the liner connections. The installation manual calls for leveling the appliance side to side and front to back, using its adjustable legs and the leveling bolts packed with the manual.
Firebox floors are often uneven, particularly in older masonry fireplaces. Our installers level the insert before the surround goes on and check it again once it is pushed into place.
How install day runs
Install day follows a set order: protect the room, remove the old doors and grate, clean and prepare the firebox, set the damper, run and connect the liners, fit the cap, make the gas and electrical connections, set the insert, fit the surround and start it up.
Our crew keeps to that order because each step depends on the one before it. You get a short walkthrough at the end and a clean room.
Other work in Apopka
-
-
-
-
-
-
Learn more about gas fireplace insert installationApopka services
Quick gas insert answers for Apopka
Short, straight answers from our fireplace team in Apopka. Anything else, just call.
Does the chimney need cleaning before the insert goes in?
Yes. Florida's Fuel Gas Code says a chimney that vented a wood fire must be examined and cleaned before a gas appliance is connected to it. We clean it as part of preparing the fireplace.
What if I smell gas after the install?
Get out of the house at once and phone 911 or your gas utility once you are outside, without lighting anything or touching switches or phones on the way. Once the utility says the house is safe, our team will come back and check the installation.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.