
Chimney chase repair and rebuilding in Carver Shores
Local, family-owned chase repair in Carver Shores, backed by our workmanship warranty and no hidden fees.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Chase repair scope for your Carver Shores home
- Moisture readings across each face of the chase
- Sheathing replaced back to firm wood
- Cricket behind a wide chase where needed
- Trim primed, installed and sealed at joints
Chimney chase repair from the top plate down
Two chimney pipes sharing one chase
Some chases hold two chimney pipes, for two fireplaces stacked on different floors or set side by side. Each pipe is its own chimney. One maker's manual, DuraVent's for DuraChimney II, says to connect only one fireplace per chimney, and each pipe keeps its own listed clearance.
A wide two-pipe chase has a bigger top, longer walls and may need a cricket behind it. More pipe also means more firestops, shields and supports to check while the chase is open. The top framing of a two-pipe chase also carries two sets of shields and openings, so rot up there has more to disturb when it is repaired.
Both chimneys get checked, including the one tied to a fireplace you seldom use. The estimate for your Carver Shores home lists work for each pipe separately, and shared items, like framing and siding, are priced only once.
Tree limbs rubbing against the chase
A limb that brushes a chase in the wind scrapes paint, loosens siding and can knock the cover out of line. Leaves and needles pile up on the roof behind it and hold water at the base. Shade from a tree also keeps one face of the chase damp longer after rain.
Trimming limbs back from the chase and the roof is one of the simplest ways to protect a repair. It also cuts down the leaves and needles that pile up behind the chase and the animals that use limbs as a bridge to the roof.
During the inspection, our technicians note any limbs that reach the chase and any damage they have done. We do not cut trees, but your Carver Shores estimate says which branches should come back before or after the repair, so your tree service knows what to do.
Chases on tile roofs
Tile roofs change how a chase base is flashed and repaired. Tiles sit above an underlayment, and water that gets under the tile runs on that underlayment toward the eave. The flashing at the chase base has to work with that whole system, not only with the tile surface. Its job is to carry water from the chase wall onto the underlayment and out over the tile below.
Tiles can also crack underfoot, so reaching a chase on a tile roof takes planning and sometimes a few spare tiles. Broken tiles are listed on the estimate so nobody is surprised by them.
For a chase base on a tile roof, we work with a roofer who handles tile, or we plan the tile removal and reset with you in advance. Who lifts and resets tile, and who flashes the chase, is settled in writing before anyone steps on the roof of your Carver Shores home.
Sequencing chase repair with a new cover
When the cover has failed and the chase under it has rotted, the order of work matters. The rotted top framing is repaired first, the siding and barrier are finished up to the top plate, and then the new cover goes on over sound wood.
Putting a new cover on a rotted top plate means taking it off again later. It also means paying to open the top of the chase twice. Repairing the chase and leaving a failed cover in place means the new wood gets wet right away.
Cover replacement is its own job with its own line on the estimate, and we schedule it right after the top framing is sound. You see both lines side by side, so you can decide on each and know the order they will happen in. If the top framing needs no repair, the cover can go on as soon as the siding reaches the top plate.
Other work in Carver Shores
-
Chimney Crown Repair Give the masonry top a sound water-shedding surface. Learn more
-
Fireplace Repair and Service Make the fireplace work for your home again. Learn more
-
Chimney Chase Cover Replacement Replace a failing chase top with a measured fit. Learn more
Chimney chase repair questions in Carver Shores
Do you work with my roofer?
Yes. Flashing at the chase base sits between the roof and the chase, so we agree with your roofer on who replaces which pieces before work starts. The written estimate spells out that split.
Is there a 10% discount for chase work?
Yes. Chase repair booked within 72 hours after your free inspection is 10% off. Mention it when you book so it is applied to your chase work.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.

