Prefab fireplace replacement and new installs in Crescent Park
Measured, planned in writing and installed to the listing. That is how our Crescent Park team builds every fireplace.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Before any fireplace is ordered for your Crescent Park home
The room, the attic and the roof are measured in person in Crescent Park, and each result lands on your estimate.
- Noncombustible face finish chosen with you
- Mantel line marked from the manual
- Drop cloths and dust control during the work
- Your 10% off for booking within 72 hours, written on the estimate
A fireplace installation in Crescent Park, start to finish
Each point below turns into a line on your written estimate in Crescent Park.
Chimney parts from the same system
Factory-built fireplace manuals specify the chimney system to be used. The E-series manual we reference requires its maker's own chimney system and shows only the chimney components that may be safely used with the fireplace, from straight sections to offsets, firestops and termination caps.
Mixing parts from another brand because they look alike breaks the listing, even when the diameters match. Our estimate lists each chimney component by the system it belongs to, and we do not substitute on install day because a supplier ran short.
Carbon monoxide alarm rules for new fireplaces
Florida Statutes section 553.885 requires new buildings and additions that have a fossil-fuel-burning heater or appliance, a fireplace or an attached garage to have an approved operational carbon monoxide alarm installed within 10 feet of each room used for sleeping, or at other locations the Florida Building Code requires.
Where a new fireplace is part of an addition, that alarm requirement is part of the project. We point it out at the planning stage and list the alarm work separately.
Opening the roof for the chimney
A new chimney needs an opening through the roof, framed between rafters or trusses where possible and closed around the pipe with the listed roof parts and a storm collar. Where a truss sits in the way, the route is rethought rather than cut through without a design answer.
Our crew closes any open roof at the end of each working day and finishes the roof covering around the chimney parts as their instructions show. The estimate states how we will reach the roof and how the surface is protected while we work.
What never goes into a fireplace
EPA lists what should never be burned: household trash, cardboard, plastics, foam, colored ink on magazines and packaging, and coated, painted or pressure-treated wood. Construction offcuts left over from the fireplace project often fall into that last group.
We mention it at handover because a pile of painted trim and treated lumber next to a new fireplace is a common sight after a renovation. Those scraps belong in a dumpster, never in the firebox.
Other work in Crescent Park
-
-
-
-
-
Learn more about fireplace installationCrescent Park services
New fireplace questions, answered for Crescent Park
Short answers from our fireplace installers in Crescent Park. Anything else, just call.
Do you remove the old fireplace?
Yes, when it is part of the scope. We open the face, remove the chimney from the roof down, slide out the old firebox and haul it away, then install and finish the new system.
Is a smell during the first few fires normal?
For a short while, yes. The early fires cure the paint and the materials inside the firebox, and most manuals ask for a run of smaller fires first. We light the first one with you, watch the draft with the doors open and shut, and suggest a window open while the curing finishes.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.