Local gas insert installation in Crescent Park
A gas insert installed to the maker's instructions in Crescent Park, with the barrier screen in place and the controls explained.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Before we order an insert for your Crescent Park home
Our local pros in Crescent Park record points like these before an insert is ever ordered.
- Masonry or factory-built fireplace, and what the insert manual allows
- Termination cap sealed and secured to the chimney top plate
- Barrier screen front ordered with the insert
- Conversion notice label fixed inside the firebox
How our Crescent Park crew fits a gas insert
Each point below comes from the insert manuals and the gas code, and each one shapes your Crescent Park estimate.
Cleanout doors that stay tightly shut
Many masonry chimneys have a small cleanout door near the base, on an outside wall or inside a garage. Section 503.5.6.2 of the Fuel Gas Code says cleanouts must be examined, and repaired or replaced where they do not stay tightly closed. The insert manual adds its own reason: a loose cleanout lets air leak into the chimney.
It is a small part with a real effect on how the vent behaves. We check the door, its frame and the latch while we look over the rest of the chimney. If it needs work, that repair is priced on its own and finished before the insert is installed.
Keeping insulation off the vent
The vent carries hot exhaust, and the manual is firm about the space around it. Heat & Glo warns installers not to pack the air space around the vent with insulation or other materials, because that can lead to overheating and fire.
At the damper, we use only the non-combustible material the manual allows, in the way it allows it. Everywhere else, the liners run through the open chimney with the clearance their instructions give them.
Fewer bends, steadier flame
Flexible liner can snake around offsets, but every bend adds resistance to the exhaust. The venting diagram in Heat & Glo's insert manual carries a plain note: for optimum performance, minimize or avoid bends in the exhaust vent pipe.
Many chimneys run fairly straight once they clear the smoke chamber. We route the liners as directly as the chimney allows and avoid extra loops, which keeps the exhaust moving and the flame steady.
Protecting the valve during pressure tests
Gas piping is pressure tested when it is installed, and test pressures are far higher than an insert's valve can take. Heat & Glo warns that pressure above half a psig will damage the gas valve control, and tells installers to disconnect the appliance and its shutoff valve before line pressure testing.
We coordinate the order with whoever tests the line, so the insert is isolated during the test and connected afterwards. It is one of those steps that only matters if someone forgets it.
Other work in Crescent Park
-
-
-
-
-
-
Learn more about gas fireplace insert installationCrescent Park services
Quick gas insert answers for Crescent Park
Short, straight answers from our fireplace team in Crescent Park. Anything else, just call.
Will a gas insert work during a power outage?
Many electronic-ignition inserts include a battery pack for outages, and Heat & Glo's Supreme series is one. The maker treats batteries as an emergency power source only. We show you how your model handles an outage at handover.
What happens to my old damper?
It is locked fully open or removed, as the insert manual directs, so the liners can pass through. The gap around the liners is then closed with the material the manual allows.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.