Chimney flashing repair for Eagles Nest homes
Local specialists replace chimney flashing in Eagles Nest with metal and methods matched to your roof covering. No hidden fees.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
What we check on Eagles Nest roofs before reflashing
Every line here is part of the free inspection in Eagles Nest, with no charge and no obligation.
- Each chimney face where it meets the roof
- Counter flashing and the joints that hold it
- Mortar condition where counter flashing anchors
- Ladder placement and protection for your property
How we handle chimney flashing repair in Eagles Nest
Practical points from our chimney flashing crew in Eagles Nest.
The apron along the downhill face
The apron is the flashing across the front of the chimney, the side that faces down the roof. It lies over the roofing below it and turns up the masonry, so water running off the chimney face lands on the shingles or tile instead of behind them.
Aprons usually fail at their ends, where they fold around onto the sides and meet the first step piece. A split fold, or an apron cut too short to wrap the corner, lets water under the roofing right at the bottom of the chimney. We check the fold, the laps and how the counter flashing covers the apron's upper edge.
How far counter flashing should lap the base
The overlap between counter flashing and the base flashing beneath it is what keeps blowing rain from getting behind the seam. BIA Technical Note 19B calls for the counter flashing to lap the base flashing by at least 3 inches.
Short laps are common on older repairs where a new piece was cut to suit an old joint. From the yard they look fine. On the roof we measure the overlap on each face and note any stretch that falls short, because a lap that is too shallow can let water in even when every piece looks intact.
Upper pieces lap over lower ones
When flashing goes on in sections, the direction of each lap matters as much as its length. BIA Technical Note 19B says a piece higher up the roofline should lap over the lower piece by at least 2 inches, so water flowing down is always carried onto the next piece and never under it.
A reversed lap, where a lower piece was slipped over an upper one during an old repair, works like a funnel. It is easy to miss from the ground and hard to cure with sealant. We read each seam's direction and correct any lap that runs backwards.
Lifting tile around a chimney without collateral damage
Old clay and concrete tiles can crack when they are stepped on or pried loose. Reaching chimney flashing on a tile roof means removing tiles around the base, stacking them where they will not slide and resetting them once the new metal is in.
We walk tile roofs only where the load can be spread, and we plan the route before anyone climbs. Your estimate lists how many tiles we expect to lift and how breakage is handled, including whether matching replacements can be found. That keeps a flashing repair from turning into a patchwork of mismatched tile.
Other work in Eagles Nest
-
-
-
-
-
Learn more about chimney flashing repairEagles Nest services
Chimney flashing questions from Eagles Nest
Answers from our specialists in Eagles Nest, with no sales pressure.
Could our downspout be part of the problem?
It can. When an upper roof drains onto the roof beside the chimney, one flashing face takes the whole stream, and even good flashing can be overwhelmed. We check where upper downspouts empty. Moving or extending one is gutter work, which we point out and leave to you or your gutter contractor unless we agree otherwise.
We have a skylight near the chimney. Could that be the leak?
It could. A skylight carries its own flashing, often from its maker's kit, and the two can share a strip of roof, so water past one can show up beside the other. We check both and tell you which is letting water in, then quote the skylight side in writing or send you to the right trade.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.